Router always Starting in ROMMON mode
Ts8060
mode.
Then when i type rommon1>reset router works fine.
How can i repair it.
I need it normally starts.
geo...@gmail.com
You need to change the configuration register.
rommon 1 >confreg 0x2102
Then you should reset.
Giorgos
--
NetPros Community
Connecting IT Pros from all over the World
http://netpros.freeforums.org
Fathi
check your register controller, what s the value, in the normal working way,
it have to be x02102,..
you can see the registers value in the ( show version command )
Have a good day
"Ts8060" <ts....@gmail.com> wrote in message
news:119b42c1-0942-4cae...@13g2000prl.googlegroups.com...
Ts8060
> Hi Ts8060,
>
> check your register controller, what s the value, in the normal working way,
> it have to be x02102,..
> you can see the registers value in the ( show version command )
> Have a good day
>
>
> news:119b42c1-0942-4cae...@13g2000prl.googlegroups.com...
>
> > If power fails then when my router starts always starting in rommon
> > mode.
> > Then when i type rommon1>reset router works fine.
> > How can i repair it.
> > I need it normally starts.
In Show Version command My Register Value is 0x2102.
But when power fails then router starts in rommon mode.
Can i fix it.
Bob Goddard
Perhaps you have something connected to the console port which starts up
at the same time and sends the break signal.
David Kerber
1.individual.mailtrap.org.uk says...
That was my thought as well. I found that leaving the console port
connnected to Windows NT when they both were coming up after a power
loss would put the router into rommon mode. I just scripted up the
commands to reset the router, and set the script to run at OS startup.
That slightly delays the router coming on line, but it worked fine.
(once we changed OSs on the computer, it wasn't an issue any more).
--
/~\ The ASCII
\ / Ribbon Campaign
X Against HTML
/ \ Email!
Remove the ns_ from if replying by e-mail (but keep posts in the
newsgroups if possible).