You do not have permission to delete messages in this group
Copy link
Report message
Sign in to report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to
Hi everyone,
I am trying to use ADE XL to perform a parametric sweep of some parameters.
If I only input 1 set of parameter values, the test runs fine and there are no issues.
Once I add another value to sweep in the parameter (i.e. Voltage = 1,2) then ADE XL is stuck in pending.
No job log is created and it will stay in pending until it timeouts.
Any ideas?
Thanks!
nhuttan...@gmail.com
unread,
Sep 27, 2020, 5:33:51 PM9/27/20
Delete
You do not have permission to delete messages in this group
Copy link
Report message
Sign in to report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to
Try spacing instead of comma, i.e. 1 2
Hope it work