Connecting to Crestron Processors that have authentification enabled
69 views
Skip to first unread message
DeathtrapDan
Mar 26, 2021, 1:46:55 PM3/26/21
to CommandFusion Software
Hi,
I cannot figure out how to Connect iViewer to Crestron porcessors that have authentification enabled.
I can set the SSL ports to 41796 for SCIP and enable SSL in the System, but nowhere can I find where/how to add the login username/pword within GUI designer. Debugger shows it connects but immediately disconnects.
Im using the CIP module and would prefer to stick with that method if I can fix this and make it connect.
any help greatly appreciated.
Thanks,
Dan
I can set the SSL ports to 41796 for SCIP and enable SSL in the System, but nowhere can I find where/how to add the login username/pword within GUI designer. Debugger shows it connects but immediately disconnects.
Im using the CIP module and would prefer to stick with that method if I can fix this and make it connect.
any help greatly appreciated.
Thanks,
Dan
DeathtrapDan
Mar 29, 2021, 12:41:26 PM3/29/21
to CommandFusion Software
Please ignore this question, as it randomly seeingly connects just fine each time now. No credentials were even needed. Thanks
AV Master
May 2, 2021, 12:18:10 AM5/2/21
to CommandFusion Software
Are you running the latest 4 Series firmware? What hardware definition are you using on the Crestron side? I’ve tried everything and cannot get CF to connect to any 4 Series at all. I get feedback on the connect join number 9000 but no communication takes place between the two.
Reply all
Reply to author
Forward
0 new messages