Repeat Function of a button with sending an ir

[Hiro]

I have an issue with volume buttons.

Now there are buttons, called .Vol UP (with Rs-232C) and Vol UP (with IR)

Those are checked "repeat delay", so that while I press, the volume will move and if I release, the volume will be stopped and set.

With RS-232C works fine. Perfect! (repeat delay : 80ms .This speed is very smooth and natural.)

But with IR has problem.

That is, "although I release the button, it keeps sending IR sending for a while."

Although I changed the shorter (like 40ms) and longer (like 200ms) 

It's still same.

I want to stop sending IR signal as soon as I release the button.

Would you please advise me the solution.

P.S

I am using LANBridge and IR Blaster.

[Jarrod Bell]

Make sure the repeat count of your IR code is only 1 to begin with (via the IR Learner software).
You can test this by doing a single send of the IR code and make sure it only increments the volume by one.

Then your repeat delay on the button will need to be something you play with until you find the sweet spot.
The way you are sending the IR code is not the same as how it works when you hold the button on your remote.
So you need to allow time for the IR device to process each command sent as a new IR burst each time (with header and repeater data) - whilst the original remote would only send the header data and then continuously repeat the repeater data section until you stop pressing the button (most likely).

You might need a repeat delay more like 500ms, but play around with it.

Regards,

Jarrod Bell
CommandFusion
www.commandfusion.com

--
 
 

[Hiro]

Thanks, Jarrod.

It works fine!!

2013年1月21日月曜日 11時48分52秒 UTC+9 Jarrod Bell:

[Hiro]

Jarrod,

Sorry for posting again.

Is it possible to modify "min repeat" which is stored in CF Mini or IR Blaster, or "On Board Database" of  database file of "CF Learner"?

Ex, Although I found the correct database ir file from "CF Mini", I can't change the value of "min repearts"

To do that, now I flash from the IR Blaster and learn the signal by CF IR Learner. This is not smart..

Please advise me if you have good method.

Regards,

2013年1月22日火曜日 9時32分47秒 UTC+9 Hiro:

[Jarrod Bell]

You cannot changed the repeat counts for IR Database commands at the moment.
Perhaps this can be achieved with a firmware update.

So for now, your approach of learning the DB command in will be the only option if you need to adjust repeats and can't simply learn from the device's remote.

Regards,

Jarrod Bell
CommandFusion
www.commandfusion.com

--
You received this message because you are subscribed to the Google Groups "CommandFusion Software" group.
To unsubscribe from this group and stop receiving emails from it, send an email to commandfusio...@googlegroups.com.
For more options, visit https://groups.google.com/groups/opt_out.