Cluster HAT v2 Case from ModMyPi

[Chris Burton]

Hi,

 I spotted the assembly instructions for the case appeared back in November and I've been impatiently hitting refresh until the product appeared so I could order a couple and they arrived today :).

Assembly was fairly painless but there was a couple of niggles. The PI Zero Micro USB (PWR) connector just catches on the "light pipe locator" but with a little filing the Pi Zeros fit straight in and click if they still have the new "click" sound (it should be OK to leave them at the slight angle tho). I also found it easier to attach the light pipes (don't forget to take the film off these!) with just the top on so I could see and guide them into the locating bracket and then put the sides/bottom back on after. The USB Serial is also a little tight in the breakout hole but it does just fit.

I think it looks quite neat sat on my desk and the light pipes work really well, has anyone else picked one up?

The URL for the case is https://www.modmypi.com/raspberry-pi/cases-183/raspberry-pi-b-plus2-and-3-cases-1122/cases-for-hats-and-boards-1133/cluster-hat-case (Cluster HAT v2 only).

Chris.

[DeanS]

Great case, would prefer it if it was transparent though!

[Will Sargent]

I did: https://twitter.com/will_sargent/status/956281045380296707