Spent some time at the Hive today and replaced the damaged, by me, spoilboard. I think we can flip the other spoilboard and run the surfacing bit to get a nice surface. The BigCNC is usable but the spoilboard might not be properly "flat".
Brad
John,
--
You received this message because you are subscribed to the Google Groups "Hive13 Hackerspace" group.
To unsubscribe from this group and stop receiving emails from it, send an email to cincihackerspace+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
I think a nice, easy to follow instruction sheet could be posted on the wiki, but having a legible (and tough) printed document that lives by the CNC would be very useful.
I'd like to make a holder for the imperial collets, maybe with the size carved into each spot.
Brad
--
Ha.Thanks for looking into it.I was referring to the far X travel. I manually moved to the far "right" to check for the surfacing bit catching all the way to the edge. The spindle pushed out the end cap and seemed ready to go clean off the gantry. I cut away the end cap so the bit could surface all the way to the edge.I'm assuming there is some max X travel in the setup. With the X axis zero defined by the prox switch (far left) it should not travel past the end of the gantry.
Thanks again,
Brad
Thanks,
Brad
To unsubscribe from this group and stop receiving emails from it, send an email to cincihackerspa...@googlegroups.com.
--
You received this message because you are subscribed to the Google Groups "Hive13 Hackerspace" group.
To unsubscribe from this group and stop receiving emails from it, send an email to cincihackerspace+unsubscribe@googlegroups.com.
From: Brad Walsh Sent: Thursday, August 10, 2017 11:49 AM Reply To: cincihac...@googlegroups.com Subject: Re: [CHP] Re: Big CNC |
All of the other profiles are OLD. From when we first set up the machine. Yes, we should do this.Sent from my BlackBerry 10 smartphone.
From: Brad WalshSent: Thursday, August 10, 2017 11:49 AM
Oops, I must have missed the notification that there was a new release. Our computers have now been upgraded to Vectric 9.0.
- Ian B.
--
You received this message because you are subscribed to the Google Groups "Hive13 Hackerspace" group.
To unsubscribe from this group and stop receiving emails from it, send an email to cincihackerspa...@googlegroups.com.
I'm not sure, it is whatever was current as of Monday afternoon. Either way, only major version upgrades require special credentials. Anyone can select "Update" from the application menus and get the latest patches.
- Ian B.