Garador Gdo 11 Manual

[Berniece Leonhardt]

Thisgarage door opener is designed and tested to offer safe service provided it is installed, operated, maintained and tested in strict accordance with the warnings, safety instructions and instructions contained in this manual.

When you see these Safety Symbols and Signal Words on the following pages, they will alert you to the possibility of serious injury or death if you do not comply with the corresponding instructions. The hazard may come from something mechanical or from electric shock. Read the instructions carefully.

When you see this Signal Word on the following pages it will alert you to the possibility of damage to your garage door and/or the garage door opener if you do not comply with the corresponding instructions. Read them carefully.

ButtonFunction1Close2Close indicator3Stop4Open5Open indicator6Mode7Status indicator8Battery status indicator9Remote status indicator10Adjustment indicator11Network indicatorMANUAL DOOR OPERATIONTO DISENGAGE THE OPENER

It is recommended to disengsgre the door with the door in the closed position.

CAUTION: When the opener is manually disengaged, the door is no longer locked. To lock the door manually, re-engage the opener after the door is closed.

TO ENGAGE THE OPENER

CODING REMOTE FROM THE OPENER

The opener can only be operated from remote controllers that have been programmed into its memory. Up to 64 remotes can be programmed. tip

STEP ONE

Switch power on and remove controls cover

REMOTELY CODING A REMOTE CONTROL Remotely coding works when you have a pre-coded remote control and are in range of the opener. tip

STEP ONE

Main Light = Service / Warning Indicator:

Requirements for a service and user warnings are indicated after operation by the main light repeatable fashing OFF a number of times followed by a pause.

The below table identifies the issues and remedies

@manualsplus YouTubeManuals+,Privacy PolicyThis website is an independent publication and is neither affiliated with nor endorsed by any of the trademark owners. The "Bluetooth" word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. The "Wi-Fi" word mark and logos are registered trademarks owned by the Wi-Fi Alliance. Any use of these marks on this website does not imply any affiliation with or endorsement.

Error code 1-5 suggests a few possible issues with your garage door opener rather than a single specific problem. The source of the malfunction can be the electric opener, the garage door, or both. If your garage door opener fails to open or close the garage door, you can use the manual release function until the problem is fixed. Read on to find out how to fix the issue based on your symptoms.

Possible issues include a binding garage door, balance issues, obstructions in the door path, broken or worn rollers, springs, hinges, bent or misaligned tracks, and sections. Begin by disconnecting the garage door from the opener using the manual release, then operate the door manually and test its balance.

Although sometimes error code 1-5 can be an easy fix, in more complex situations, the error can suggest that there are multiple issues with the garage door and the garage door opener. For example, there can be a scenario where multiple defective parts will need replacement, like the control board, the motor and the springs.

Ongoing preventative servicing ensures that your door continues to function within factory specifications, greatly reduces the risk of failure and repair bills down the track and ensures you maintain your Warranty.

However, all exposed surfaces require some attention to guard against the premature onset of corrosion and any other harmful atmospheric effects. In our atmosphere there are harmful deposits that gather on the door surface and if not removed regularly, will seriously affect the appearance and life of the door.

B&D recommends that you check the operation of your Sectional Door at least every six months (more regularly in extreme environments or frequent use). The effort required to manually open and to manually close the door should be about the same (if door has an automatic opener, put into manual mode before testing door).

To keep your door running well, it is recommended that your door be serviced, by an experienced door technician, within the first 12 months on installation and then every 2 years (more regularly in extreme environments or frequent use), or earlier if required.

COLORSTEEL FINISH Your B&D Roll-A-Door door has been pre-painted with a silicone modified polyester formulation, which is one of the best paint films commercially available today. However, all exposed surfaces require some attention to guard against the premature onset of corrosion and any other harmful atmospheric effects. In our atmosphere there are harmful deposits that gather on the door surface and if not removed regularly, will seriously affect the appearance and life of the door.

We suggest you record your full Key letter and Number on the front of this manual and if replacement keys are required, they can be obtained from your nearest B&D office, simply by quoting this number. If the keys have been lost and the number not recorded, it can be found stamped into the locking arm at the back of the mechanism.

Care should be taken not to damage the Nylofelt, however, if Nylofelt is cut or damaged, a lighted match should be used to quickly seal the ends of the nylon braiding, so as to stop any further deterioration.

B&D recommends that you check the operation of your Roll-A-Door at least every six months (more regularly in extreme environments or frequent use). The effort required to manually open and to manually close the door should be about the same (if door has an automatic opener, put into manual mode before testing door).

If you have checked these (and corrected where necessary) and the door is still difficult to operate, , then your door will need a service to adjust the spring tension and possibly other operational parts of the door.

This service should only be carried out by an experienced door technician, using the correct tools.

If you have an automatic opener fitted to your door, it is particularly important that you ensure the optimum operation of the door, otherwise you may reduce the effective life of the opener.

To keep your door running well, it is recommended that your door be serviced, by an experienced door technician, every 12 months (more regularly in extreme environments or frequent use), or earlier if required.

Warranty conditional on proper care as recommended above. Full details of the warranty are available in your owners handbook. Tilt DoorsGeneral Care of Your Tilt-A-Dor T-FittingCleaningIt is recommended that your fittings be serviced, by an experienced door technician, every 12 months (more regularly in extreme environments or frequent use), or earlier if required.

The spring is under tension at all times and may cause serious injury if interfered with by an inexperienced person. Adjustments and repairs should be carried out by approved B&D dealers using proper tools. Nobody should ever stand directly in the path of the door in its downward travel or walk through doorway while door is moving.

Dominator and Garador combine to form a network of more than 70 B&D Group Authorised Dealers across New Zealand ensuring that every B&D manufactured product is backed by the highest levels of customer service and support.

B&D Authorised Dealers undergo extensive training in all aspects of our products, including installation and maintenance procedures. In addition, they attend yearly conferences to update their product knowledge and review their customer service performance.

As an expert in garage doors and openers, your local Dominator or Garador Dealer is able to provide comprehensive advice on the best solution for your individual requirements as well as the assurance that all service and maintenance issues will be dealt with efficiently and effectively.

3a8082e126