Guido
--
. + .-'''''-. . # . . + . . * . * .
. .' `. + . Guido Silva Carvajal * * *
: : . . * Ingenieria Civil . + . * .
# . : : . Universidad de Concepcion .
: _/| : o + . . * . . + . + .
. * : =/_/ : . . gsi...@ing.udec.cl . . o
`._/ | .' . + http://www.ing.udec.cl/~gsilvac . *
o . ( / ,|...-' . . + . . + . .
\_/^\/||__ + "Ya no la quiero, es cierto, pero tal vez la quiero.
. _/~ `""~`"` \_ Es tan corto el amor, y es tan largo el olvido.
. __/ -'/ `-._ `\_\_ Porque en noches como esta la tuve entre mis brazos,
/ /-'` `\ \ \-.\ mi alma no se contenta con haberla perdido."
Guido Silva Carvajal wrote:
> Hola
> Tengo un Pentium con un problema:
> Cuando es encendido, solo alcanza a lanzar dos beeps largos
> seguido por una gran cantidas de beeps cortos, alguen
> sabe que significa esto, probe memorias, video, cpu y nada.
> El disco duro esta bueno, y sin virus.
> Bueno, eso seria.
> Salu2
>
Hola....mira esto es de AMI BIOS, no se si son diferentes los beeps pero quizas
te sirve de algo, está en Ingles:
- 1 beep: DRAM refresh failure. The memory refresh circuitry on the motherboard
is faulty.
- 2 beeps: Parity Circuit failure. A parity error was detected in the base memory
(first 64k Block) of the system.
- 3 beeps: Base 64K RAM failure. A memory failure occurred within the first 64k
of memory.
-4 beeps: System Timer failure. Timer #1 on the system board has failed to
function properly.
- 5 beeps: Processor failure. The CPU on the system board has generated an error.
- 6 beeps: Keyboard Controller 8042-Gate A20 error. The keyboard controller
(8042) contains the gate A20 switch which allows the computer to operate in
virtual mode. This error message means that the BIOS is not able to switch the
CPU into protected mode.
- 7 beeps: Virtual Mode (processor) Exception error. The CPU on the motherboard
has generated an Interrupt Failure exception interrupt.
- 8 beeps: Display Memory R/W Test failure. The system video adapter is either
missing or Read/Write Error its memory is faulty. This is not a fatal error.
- 9 beeps: ROM-BIOS Checksum failure. The ROM checksum value does not match the
value encoded in the BIOS. This is good indication that the BIOS ROMs went bad.
- 10 beeps: CMOS Shutdown Register. The shutdown register for the CMOS memory
Read/Write Error has failed.
- 11 beeps: Cache Error / External Cache Bad. The external cache is faulty.
Other AMI BIOS POST Codes
- 2 short beeps: POST failed. This is caused by a failure of one of the hardware
testing procedures.
- 1 long & 2 short beeps: Video failure. This is caused by one of two possible
hardware faults. 1) Video BIOS ROM failure, checksum error encountered. 2) The
video adapter installed has a horizontal retrace failure.
- 1 long & 3 short beeps: Video failure. This is caused by one of three possible
hardware problems. 1) The video DAC has failed. 2) the monitor detection process
has failed. 3) The video RAM has failed.
- 1 long beep: POST successful. This indicates that all hardware tests were
completed without encountering errors.
Chao!
Kenneth
Atte.
Jose
Guido Silva Carvajal escribió:
> Hola
> Tengo un Pentium con un problema:
> Cuando es encendido, solo alcanza a lanzar dos beeps largos
> seguido por una gran cantidas de beeps cortos, alguen
> sabe que significa esto, probe memorias, video, cpu y nada.
> El disco duro esta bueno, y sin virus.
> Bueno, eso seria.
> Salu2
>