New CS1 Host version out!

[Hradec]

New CS1 Host version out! - http://www.chemshapes.com/?p=674

[Milan Augustin]

In Annex I send pictures and ring test cubes 10 x 10 x 10mm to be placed on a blog.
The cube is printed on 0.027 mm - so the model has a printed size of 10 x 10 x 5 mm. When quality and draiver engine can be reduced up to approximately 0.003 mm, but this has no practical significance. Pitch 0.025 to 0.03 mm is quite sufficient.

2012/4/19 Hradec <hra...@hradec.com>

[Milan Augustin]

Hello
We managed to calibrate my printer with CS1.
See print. attached image.
Model - Rhino 10 x 10 x 10mm
Printed model 10.07 x 10.12 x 10.09 mm.
A layer of 0.029 mm.
Zoom CS1 4.10%.
For accurate calibration, it is necessary to modify the resolution of the image (PNG). For my printer (1280, 913).
Please add the possibility to set the resolution in CS1 size cut imposed (PNG) (For each printer is different).
Please some other version of CS1, if possible, add the possibility to adjust the color image (PNG)
viz. the second image.
  Thank you and good luck

[Hradec]

Thanks a lot, Ago!
Do you have a blog link or something for me to add to the blog post with your photos?

[Hradec]

Can I ask you a favor? Could you add an "official" request in the issue tracker:

http://code.google.com/p/chemshapes/issues/entry?template=Review%20request

Although it's called "issue tracker", It can be used for feature request as well.. Just add a "Review Request" and write down what you wan't to see in the CS1.

That way I won't forget ANY requests/issues!! :)

thanks lots!!!!
-H