AnyCubic Predator retrofit

[Vickie Sa]

I'd like to use my Cerambot printhead extruder on an AnyCubic Predator.  AnyCubic uses proprietary firmware that is ChituG, not Marlin.  You show the AnyCubic Kossel which I cannot seem to buy but I chose this because it was the only delta printer you had listed.  This is what you showed us:

3. Currently Cerambot is compatible with flashfore, mooz, trinus, ultimaker, prusa i3, and anycubic. Theoretically, FDM printers can use our kits. At present, we have opened some of the modules we designed, and we will open more of our designs in the future.

You do not have a "fixing nozzle module" for AnyCubic.  Can we just buy another effector like you have and mount it onto the Predator instead of having to print out a "fixing nozzle module".  You are assuming we all have 3D printers or have access to one.

As for the hardware do you suggest we move the MKS chip/board to an extrusion port (E0) on the AnyCubic board?

As for software I believe changing the firmware code is a bit different in ChituG. 

http://tronxy-3d.org/chitu-g-code-explained.html?start=20

I'm not an engineer nor do I play one on tv.  I could try to figure this out but maybe you could help me out given you say that it's compatible in all of your literature, postings and website?  From the Tronxy post we can make firmware code changes on a notepad file and upload onto the firmware via SD card and run the file like a print.

If you can't help me can you tell me exactly what changes need to be made?  My guess is that 

1) the heated bed and tip need to be turned off

2) there needs to be some sort of extrusion adjustment to take into account the change from filament to clay extruder

3) there needs to be code put in so we can change the "mixing" between the printhead extruder speed and ram clay delivery extruder

Is there anything else?

[Jony Liu]

Min Hotend Temperature for extruder to turn on

M8022 T0

Extruder Calibration

value of each step of E. This value is equal to the 1/3200 circumference of extruder gear. In addition

M8011 S0.010799（you can try S0.04）

[Jony Liu]

You can send a photo of your existing printer. I do n’t know which one. Take a picture of the fixed part of the print head. And the circuit manual and circuit wiring of your existing printer.