Air Extruder Kit arrived with no Assembly instructions

[mark....@gmail.com]

Hi I've searched both the www.cerambot.com site and this group but not found any instructions for assembling the Air Extruder.

Im printing the mounting plate off thingiverse, but would really like to find some instructions on how the Air Extruder is meant to be assembled.

[Bob Gusek]

It's in the support section under downloads on the second page.

https://www.cerambot.com/filedownload/32657

[mark....@gmail.com]

Hi Bob,
I saw that, read that, and it's not Air Extruder assembly instructions..

It presumes that the Air Extruder is assembled. Mine arrived as a box of parts with no assembly instructions.

[robert...@inmar.com]

Its got a picture of it assembled at the beginning. It basically shows you where the parts should go.

[Thor Johnson]

There's a little triangle (black-on-black) on the bottom that indicates the air flow.

If you can't see it, turn the knob all the way out (ccw), and blow into the  pressure gauge port.  The port the air comes out of is the one that goes to the clay cylinder (outlet) and the the other one (by the triangle) is the inlet.

[mark....@gmail.com]

So in short, there are no assembly instructions for the Air Extruder, just the 2 pictures in the top of "CERAMBOT Air Instruction Manual".

The key tip from Thor is to identify the little black on black triangle.

Any other assembly tips or photos?

[mark....@gmail.com]

I also found this pic:
https://www.cerambot.com/newsinfo/350806.html

There really should be an Assembly Guide...

[Bill-D IT #SRRF]

I’ll see if I can find the info.i have an air extruder kit as I bought a 3 in 1 Cerambot

[Thor Johnson]

Use teflon tape or pipe dope... it'll work without it, but without it, it will leak like a sieve and waste a bunch of air.  

I also put red sharpie on the face of the gauge to indicate what the manual said "not to exceed"  (just because I know I'd not remember it).