Faulty Power Supply

pke...@ausd.net

unread,

Nov 30, 2019, 3:49:03 PM11/30/19

to CERAMBOT

I've just finished assembly, connected the power supply, and nothing. The transformer powers on with a blue light but I tested the output and I'm only getting 60mV DC. It's probably easier to order a replacement rather than wait for one from China - does anyone know the plug type/size Cerambot uses? Thanks in advance.

mark20...@gmail.com

unread,

Dec 1, 2019, 5:08:27 PM12/1/19

to CERAMBOT

I'm assuming you are talking about the brick that plugs into the wall. Mine smoked, so I replaced

5.5x2.5 mm tip
12v 10A output
positive center, negative outside
100-240V ~50/60Hz 3A input

pke...@ausd.net

unread,

Dec 1, 2019, 5:44:42 PM12/1/19

to CERAMBOT

Yes, it is the power brick. I got bored and opened it up, the DC positive wire wasn't connected. Looked like a cold joint that hadn't stuck. I re-soldered it and it's working for now, but I think I'll look for a new power supply with better reviews and replace this one. Thanks again for the plug size and specs.

Vickie Sanders

unread,

Dec 1, 2019, 5:52:21 PM12/1/19

to CERAMBOT

If you find one on Amazon can you give us the link so we can order the same one? Thanks in advance!

Vickie Sanders

unread,

Dec 1, 2019, 5:55:48 PM12/1/19

to CERAMBOT

Would this work?

https://smile.amazon.com/SHNITPWR-100V-240V-Converter-Transformer-5-5x2-5mm/dp/B07PWZQ33N/ref=sr_1_3?crid=ZI35Y96NXWJO&keywords=12v+10a+power+supply&qid=1575240887&sprefix=12V+10A%2Caps%2C253&sr=8-3

Mark Anderson

unread,

Dec 1, 2019, 6:07:51 PM12/1/19

to CERAMBOT

That is the one that I ordered. I can verify it works to run control panel and auto home. Unfortunately, other issues prevent me from verifying that it works with pro extruder, not reason to believe it won't. Just my pro extruder is not working, so I can't verify.

Reply all

Reply to author

Forward