Question Marks for XYZ Locations

Zachary Hogan

unread,

Sep 25, 2020, 12:39:01 PM9/25/20

to CERAMBOT

Hello everyone,

I am having issues getting the CERAMBOT to read/display XYZ positions.

Marlin Firmware was successfully installed using Arduino IDE. RAMPS 1.4 is being powered by DC12V~500mA Power Adapter.

Auto Home causes all motor to stutter in place a few times, then stop. The Auto Home error is:

"Homing failed

PRINTER HALTED

Please reset"

Additionally the extruder makes noise when on hardware mode, but no movement. Noise intensity changes while sweeping the potentiometer.

Any suggestions?

Jony Liu

unread,

Sep 25, 2020, 12:42:51 PM9/25/20

to CERAMBOT

The power adapter current is too small to drive the motor. It should be around DC12v-10A.

Valérie Potvin

unread,

Dec 8, 2020, 5:58:57 PM12/8/20

to CERAMBOT

Hi Zachary,

Did you solve your problem : Additionally the extruder makes noise when on hardware mode, but no movement. Noise intensity changes while sweeping the potentiometer.

I have the same and I have no Idea what is the problem. The machine is brand new, I paid for full assembly and I can't make it work!!!

If you have a clue, I would be glad!!

Valérie

Valérie Potvin

unread,

Dec 8, 2020, 6:00:05 PM12/8/20

to CERAMBOT

Hi Zachary,

Did you solve your problem : Additionally the extruder makes noise when on hardware mode, but no movement. Noise intensity changes while sweeping the potentiometer.

I have the same and I have no Idea what is the problem. The machine is brand new, I paid for full assembly and I can't make it work!!!

If you have a clue, I would be glad!!

Valérie

Le vendredi 25 septembre 2020 à 12 h 39 min 01 s UTC-4, Zachary Hogan a écrit :

Reply all

Reply to author

Forward