CNA 1004

[dhill]

Hi All,

There is a new firmware version available for the CNA 1004 product.
The new version is 1.1.0. The nicest thing about this release is that
it is able to retain configuration information from versions 1.0.8 and
1.0.9 during upgrade. This allows for easy field upgrading without
having to worry about IP address resetting.

New files in files section:
CNA1004v1.1.0.zip
cna_config.zip (updated)

Release notes:

Version 1.1.0:
* Note: This version *requires* the latest CNA config tool. Look in
files for cna_config.zip.
** Debug printing now works slightly differently. Remote debug
messages will now automatically stop being sent within 10 minutes
after the CNA config tool closes. No need to remember to set the
debug byte back to 00.
** Local debug printing (serial port) is enabled by the new terminal
command, "debug on". Once enabled, local debug printing is valid for
24 hours. Local debug printing may be disabled using "debug off".
** The config utility now has the ability to display debug printing in
two modes. Mode 1: CNA displays debug messages from only one CNA,
the focus target identified in "File->Target IP",. Mode 2: CNA
displays debug messages from all CNAs. Mode 1 is the default. To
enable Mode 2, check the box "Options->Display all CNA traffic".
** To allow for an MCP shortcoming, inbound link addresses of 0x23 are
allowed in addition to the correct poll address.
** Added ability to upgrade from the previous config version to the
current config version without losing configuration data.

Version 1.0.9:
** Added PTT monitor and "no answer" monitor for both ARES and ATCS
bases.
** Added RNR monitor for ATCS bases.
** Added capability to reboot external radio based on monitors.
** Added ability to turn on/off the one-minute keepalive check for
ARES bases (checkbox appears for ARES bases, hidden for ATCS bases).
** Added separate timers for optoisolated output toggles 1 and 2.
** Added configuration options for radio rebooting (1) On stuck
transmitter, (2) On timeout, (3) On RNR.
** Added PTT input polarity control for PTT sense (active high or
low).
Added "radioReboot" and "aresPoll" config values and defaults, etc.

Version 1.0.8:
** Fixed HDLC RTS/CTS.
** Added wait for CTS release before next pkt Tx.
** Added timestamp on debug print messages.
** Added check for user input before printing debug messages.
** Added time / date set & display terminal commands.
** Added "ipconfig set" terminal command.