Catalina355

We have #46 and have the same issues with the refrigerator. I finally followed the advice I saw on

Hi Neil, Congratulations on your new 355! We love our Tenacious (Hull 6) as much today as the day she

Finally got to it .. connected hose to through hull while I was in starboard aft lazerette - no water

To close the loop I did disconnect the raw water hose from pump and drained fluid from hose to heat

Thank. I'll try that next week. Sent from my iPhone On Apr 24, 2025, at 9:22 AM, Charlie Wing

Found problem and fixed. There was a crack in the plastic top of strainer which let air into the low

Mike, I had similar problems with my analog voltmeter. I have a Balmar smart charging system with a

I have a furling mainsail for a Catalina 355 that was used for ~10 years in the northeast. It is a

Splashed Friday and flushing out water tanks after winterization. Our water here is high in iron,

That makes sense. I would expect the breaker/switch to be the fuse. Thanks, Dean On Sat, Apr 19, 2025

That's what I suspected. The space between the cabin floor and the support grid is about 1"

From: catal...@googlegroups.com <catal...@googlegroups.com> on behalf of Sam Paul <

Here is how i setup the seaflow dry bilge: 1. I put the pump in the forward berth closet. This

I noticed grease oozing from wheel shaft on pedestal. I don't remember seeing it in the past.

It looks like I found Jon Vez's photos showing a battery bracket, not Dave Warful's. Thank

Hope this helps

You can get it at Defender. It's a Forespar 841 duck bill valve. HVB Sent from the field. On Mar

I had exactly same situation last summer. Window on port side leaking. Had to be replaced 🙁$$$. Ernie

Excellent! Thanks so much! On Sun, Feb 2, 2025, 5:46 PM William Lieppe <wli...@gmail.com>

Thanks Bill .. much appreciated On Dec 17, 2024, at 12:28 PM, bill pittore <bill.p...@gmail.com

Oh congrats ... I know what you mean about age catching up. We have switched to a Benetean ST 34 to

This is how we do it. Use a small plastic hand piston pump, place the intake hose in the pink stuff

I am resurrecting this thread for those of us with "newer" versions of the 355. Earlier

The stuffing box nuts appear to be castings and have a lot of variability in the size measurement

Have had same issue with accessing the sink drain and after seeing this post checked on mine (#144)….

thanks Bill. I did take out switch on side of sink but the wires were too short for me to get access

Sorry for repost but video now with music so not so boring and with part links embedded (also below).

I purchased the entire Bobstay kit from Garhauer a few weeks ago. They provide all the components in

Thanks will check it out On Sunday, October 13, 2024 at 2:49:51 PM UTC-4 neca...@gmail.com wrote: I

Thank you Bill. -Eric Carnell Solstice, hull #126 On Oct 13, 2024, at 8:23 PM, bill pittore <bill.

On my boat that panel is a piece of Formica that is glued to the cabinet. If you have a long thin

Following up on the manifold conversation, I followed Bill's plan and expanded the freshwater