c320-list

When I had to lower, about 1 inch, my lower instrument pod because of interference with a new wheel

I just repacked my stuffing box with 3 rings of 1/4" Gortex. Pretty easy with a pusher I made

As you saying that the breaker pops even if you remove the wires from the breaker? If so you may have

The link did not work as is because somehow the name jeff was included at the end Get rid of Jeff:)

Steve Correct - the screws fit into holes in the bottom of the guard. Once fully removed it will

Trying to optimize my boat's set-up for some club racing, and have noticed different upwind

Did you connect Garhauer? I think you can repair these pretty easily. So yours look like these?https:

I have a dehumidifier on my Webasto AC. Anyone have any idea how much it costs tp run this 24/7 on

Hi Can anybody tell me how the kitchen table support goes together. Specifically the screw and the

Assuming it's actually a Shaefer 2100, I believe you can replace just the foils. There is no

Hi Scott, If you are into electronic tinkering then you can create bilge pump counter from a dollar

Coil up an extra couple of feet in the bottom of the mast for cutting back and changing pl-259's

Hi, Mark; Starting with your second question, the riggers that replaced my furler went up the mast

Hey David, I believe everything that came out of my boat was a #8 x 3/4 would screw. I feel like

You may want to consider replace your switch with the below unit. Not cheap, but once and done. https

Thanks for the story. Any pictures? (Usually pictures are the LAST THING one is thinking about at

Thanks for this update David. I'm about to do all six port in the next month or so, so this was

Graeme First time I dug a hole and lowered the rudder down and out.Hole depth depends on height boat

One thing I try to do which I believe extends the life of raw water pump bearings and seals is flush

Two benefits of the sound proofing are (1) obviously less engine noise (2) less heat in the aft berth

Graeme: I replaced my original bronze shaft with a stainless steel shaft a few years ago. I cut the

Hi Jeff, Sorry you are having trouble. Not sure I'm following the issue and which cover you are

I have a '95 Perkins Perama M30. I had to remove the heat exchanger due to a leak, and I now

Hello all, Next week I'm pulling out the boat for a bottom job and will be replacing both my

If anyone is looking for better pricing on Starboard (or Seaboard which is very very similar),

I only did one…I installed roller furling on our old Cal 27-T/2 and used a Sta-Lock fitting on the

Check out: Marine How To - DIY for Boaters - Marine How To | | | | | | | | | | | Marine How To - DIY

If it's an option and available, it's a good idea to only use the Yanmar (or Yanmar approved)

Northwindyachtservice.com On Thu, Apr 7, 2022 at 10:03 AM Steven Snyder <mssnydr@gmail.com>