BMW E34 ///M5

I'd check the rubber hose Gary mentions. Tightening the clamps stopped my "fuel leaks".

Travis! Thanks for the update. It's been about 7 years since I had the last Bosch done. Good to

I have a set of front springs removed from my M5. Anybody interested? Jack Wheat

That door needs welding. The koala piece is a reinforcement for a minor crack which occurs first. Don

Hi guys (long time since...). I can confirm waterpumps E34 M5 3.8 even 3.6 now again = have been NLA

Great suggestion! On 22 Feb 2025, at 14:16, Jeff Gomon <jeff...@gmail.com> wrote: Gary, These

Thanks everyone for your advice on this issue over the past week! I'm going to check and clean

Apparently my pressure bleeder wouldn't flow enough even in reverse flow (pushing fluid in slave

Fyi - one can do this with the engine in car. I'm halfway and will start assembling any day now.

Mission completed. Tried lowering crossmember. Unbolting was easy, but seemed quite stuck and I was

Many of you know Mike Renner from the performance Center. He is holding a large event in Greenville,

The car weighs only 3300 lb, about 500 less than an M5. Actually, it was delightful with the stock

In the BMW wiring diagrams BLACK in German is SCHWARZ and is abbreviated SW On Tuesday, March 8, 2022

Just attached my collector vehicle plate to the rear of the M5. Front plate not required along with

I ended up buying a generic ( Pursuestar ) knob for $15 from Amazon. It is weighted and taller than

Google E34 stomp test and you'll find a lot of info. Seem to work on some cars, but unclear

Thanks for the interest, but no way I can sell it now! On Tuesday, September 7, 2021 at 7:10:50 PM

Did the same. Use the high heat red or black because the standard stuff is not up the task. It gets

The heat shield on the underside hood insulation over the header is coming loose. Don't suppose

I will report the brands I tried and I believe I have a set in my garage. It worked in the M5 with

Thanks! For our cars, I've found many suppliers show parts available online, but do not have them

UUC owner, Rob used to have a M5 touring so I'm sure he can advise. Try contacting them Sent from

I have not been keeping up with the group as much, but I definitely remember the name, and I am so

For increased camber. We used to just elongate inward the strut bolt holes. But that was on a Datsun

This part lacks the hinge, it is painted in black primer. Make an offer, no use for it.

Was gifted a self-dimming mirror and since my car had the wiring I installed it. Manual makes more

Pics are posted to Dropbox at the link below. I added two pages from a Hemmings article that featured

Greetings. I have a set of staggered M Tech wheels with the original turbine covers, in very good to

Old plugs may leak between the shell and the ceramic. But deposits and condition of the electrodes

Temperature swings cause all sorts of humidity problems. A cold spell chills the car, then a warm