Debugging with CCs V6.2 / TI XDS100v2 USB failed becuase of Address 0x80000000

[Ashkan Golestani]

Folks,

I am new with BBB but I have enough experience with CCS and ARM and other processors .

I have created the project with C++ ,GNU Compiler and Linker also is attached to my project .

Here is my problem :

M3_wakeupSS: File Loader: Verification failed: Values at address 0x80000000 do not match Please verify target memory and memory map. (Note: I can uncheck the fast verification, But that is not the right solution )

M3_wakeupSS: GEL: File: ...\workspace_v6_2\RSM_1\Debug\RSM_1.out: a data verification error occurred, file load failed.

I don't see any option on project properties for BBB setting to select the start debugging address.

By the way if it is not 0x80000000  ! what is the number ?

Thanks in advance

Ashkan Golestani

[John Syne]

If you are trying to do bare bone development, then Starterware has a custom MLO, u-boot and GEL files necessary to configure DDR memory. Clearly the BBB DDR hasn’t been configured and that is why you are getting this error.

Regards,

John

--
For more options, visit http://beagleboard.org/discuss
---
You received this message because you are subscribed to the Google Groups "BeagleBoard" group.
To unsubscribe from this group and stop receiving emails from it, send an email to beagleboard...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/beagleboard/31da8342-4de5-4f70-81a3-c38f9592695c%40googlegroups.com.
For more options, visit https://groups.google.com/d/optout.

[Ashkan Golestani]

John,

Thanks for quick reply .Using the BBB is too complicated than I expected . Thanks again for info . I'll post to this chain if I had more issue with those packages!

Regards

Ash