Re: [beagleboard] gtkterm error

[Sid Boyce]

On 01/02/13 03:29, Halil BAY wrote:
> control signals read: input/output error in gtkterm. waht is it? --
> For more options, visit http://beagleboard.org/discuss
> ---
> You received this message because you are subscribed to the Google
> Groups "BeagleBoard" group.
> To unsubscribe from this group and stop receiving emails from it, send
> an email to beagleboard...@googlegroups.com.
> For more options, visit https://groups.google.com/groups/opt_out.
>
>
Are you using a null-modem cable? It's needed for any Beagleboard.
Regards
Sid.

--
Sid Boyce ... Hamradio License G3VBV, Licensed Private Pilot
Emeritus IBM/Amdahl Mainframes and Sun/Fujitsu Servers Tech Support
Senior Staff Specialist, Cricket Coach
Microsoft Windows Free Zone - Linux used for all Computing Tasks

[Halil BAY]

Yes, "Sid". I am using a null-modem cable. Thanks for your reply. What should i do?

[Sid Boyce]

On 02/02/13 14:19, Halil BAY wrote:
> Yes, "Sid". I am using a null-modem cable. Thanks for your reply. What

> should i do? --

> For more options, visit http://beagleboard.org/discuss
> ---
> You received this message because you are subscribed to the Google
> Groups "BeagleBoard" group.
> To unsubscribe from this group and stop receiving emails from it, send
> an email to beagleboard...@googlegroups.com.
> For more options, visit https://groups.google.com/groups/opt_out.
>
>

That is an error I have never seen.
Make sure the port is correctly set up, e.g /dev/ttyS0 for a normal
serial port connection, /dev/ttyUSB0 for a USB serial port.
Speed 115200
Parity none
Bits 8
Stopbits 1
Flow control none
End of line delay (milliseconds) 0

Hope this helps.