DCAN0 bus speed setting anomaly

[Glenn Cutler]

Hello, 

I'm using DCAN0 on the Beaglebone Black to talk to a couple of other devices on a 125 kbps CAN bus. Everything is working fine but I had to request a can bus speed of 135 kbps (i.e. "ip link set can0 up type can bitrate 135000") in order to get DCAN0 actually running at 125kbps. I've verified with a scope that the bit time is 8us when I set the bus speed to 135kbps. In fact, further testing at different speeds showed that in order to get any particular bus speed, I had to consistently command a speed 8.67% higher.

Has anyone else encountered this problem? Can anyone offer a suggestion as to what might cause this behavior? I've seen this on both a Rev A5A board and a RevC board. I've also tried different images to no effect.

[evilwulfie]

that makes no sense whatsoever
we connect ours to a Xanbus system if the bus speed was off that much the system would crash

--
For more options, visit http://beagleboard.org/discuss
---
You received this message because you are subscribed to the Google Groups "BeagleBoard" group.
To unsubscribe from this group and stop receiving emails from it, send an email to beagleboard...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.