Discrete I/O power
1 view
Skip to first unread message
sethd...@gmail.com
Feb 20, 2008, 8:26:23 AM2/20/08
to AVIDdirector-M2M
Hello,
Is it possible to wire the discrete inputs on the AvidDirector 200
(terminals 5-8 and 11-16 on the expansion board) with 24 volts?
Thanks.
Is it possible to wire the discrete inputs on the AvidDirector 200
(terminals 5-8 and 11-16 on the expansion board) with 24 volts?
Thanks.
![Rod Montrose[AVIDwireless]'s profile photo](http://lh3.googleusercontent.com/a-/ALV-UjWteEPGFFAaVEUrf3gKqI2z-T1pvnSJ40qdw77v4UOtL1Zk73VuBQ=s40-c)
Rod Montrose[AVIDwireless]
Feb 20, 2008, 1:26:42 PM2/20/08
to AVIDdirector-M2M
Not directly, but you can with the appropriate interface circuitry.
For example, the demo board uses PS2501-4 Opto-isolators (see
http://www.cel.com/pdf/datasheets/ps2501.pdf) for the input to provide
isolation from the input bus and can be set to accept almost any input
voltage with the appropriate input resistor. For the output it uses
PCJ-105D3MH,000 relays which switch up to 240VAC at 5A. See the Demo
board schematic at http://aviddirector-m2m.googlegroups.com/web/Demo%20Board-RevC.pdf
-- Rod
On Feb 20, 7:26 am, "sethdhoo...@gmail.com" <sethdhoo...@gmail.com>
wrote:
For example, the demo board uses PS2501-4 Opto-isolators (see
http://www.cel.com/pdf/datasheets/ps2501.pdf) for the input to provide
isolation from the input bus and can be set to accept almost any input
voltage with the appropriate input resistor. For the output it uses
PCJ-105D3MH,000 relays which switch up to 240VAC at 5A. See the Demo
board schematic at http://aviddirector-m2m.googlegroups.com/web/Demo%20Board-RevC.pdf
-- Rod
On Feb 20, 7:26 am, "sethdhoo...@gmail.com" <sethdhoo...@gmail.com>
wrote:
Reply all
Reply to author
Forward
0 new messages