How to cut holes in assembly?

[Roki]

I have a problem since I don't know how to cut holes in assembler
through several plates. Is there anybody that can help?

I need to cut about 100 holes through 3 plates. Right now I'm doing it
the hard way. I cut a hole through the 1st plate and now I have to cut
the hole through the 2nd plate. In assembly I use 'edit' on the 2nd
plate then command 'project geometry' and project holes from the 1st
plate. When I have projected holes on the 2nd plate, I again use
command 'hole' to finally make hole on 2nd plate. I have to repeat this
process on the 3rd plate.

I could use a hint.

[mmhanafy]

You can use a software from Mold n More Called
Drilling Tool find it "www.moldandmore.com"
am their reseller in Egypt, it Work Under Inventor

[kitt...@yahoo.com]

you can avoid doing holes in the plates. individually.
1) assemble three plates
2) in assembly mode create sketch for hole.
3) create hole it (through all). you get the hole in all the plates
(coaxial)
Need further clarification
emai me at mkri...@stratacontrol.com.au

[Roki]

Thank you for answer, but I need holes i parts not i assembly.
I tried moldandmore.com,it was correkt tip.