Copy/Hatch Bug

[Dale dawson]

The following sequence showed up when I tried to do the following:
I used bhatch to hatch an irregular boundary, and a rectangle at the same
time.
I then wanted to copy just the rectangle, (Creating a legend) and so
selected both the hatch and the rectangle using a crossing box.
Then I removed the hatch selection using the shift key and picking the hatch
object.
It seems to have removed it, so I pick my displacement refernence point,
pick a new location, and suddenly it asks if I really want to do this 9 Dont
know where the 1028 came in as there were no additional picks. I decided to
tell it yes because I wanted to know what it was going to do.
After about two minutes of seeming inactivity, I cancelled. Is this a
problem caused by associativity???

Command: CP COPY
Select objects: Other corner: 2 found

Select objects: 1 found, 1 removed

Select objects: <Base point or displacement>/Multiple: Second point of
displacement: <Ortho on> 1028 selected,
Do you really want to do this? <N> Y Scan terminated by Control-C

[Ahmet Nejat EKEBAS]

Dear Dale,

I think you have some mistakes.

1-While you are using Bhatch command, is the Explode option is checked. If
it is, please don't check Exploded option then retry your process again.

2-Did you explode the hatch after you use Bhatch command.

3-Did you hatch the irregular boundary and rectangle TWICE, or one of them,
by mistake.

4-Maybe your screen's refresh is low, before run the copy command regen your
screen. Look carefully whether you have double hatch or not.

EKE

Dale dawson wrote in message <73fcrr$s0...@adesknews2.autodesk.com>...