Still having problems w/ STB Velocity 128

[Stan Hampton]

I have updated the driver from the STB web site (1.66) and am still having
problems with lines not displaying!
Does anyone have any other suggestions?

[Carolyn Brill]

Are these plines that are not displaying? Check their width setting? What
layer?

Did you already try booting in VGA mode (NT) or Safemode (Win95) to see if
the lines display in VGA?

Carolyn Brill
ACAD Product Support, US
WW Support & Services, Autodesk
Discussion Q&A: http://www.autodesk.com/discussion

Stan Hampton wrote in message <6k40m5$el...@adesknews2.autodesk.com>...

[Stan Hampton]

Carolyn,
Thanks for your response.
The problems seem to occur w/ both lines and plines, often it is only a
portion of a line or pline. It happens in several different layers and
colors. They seem to display correctly in win95 safe mode!
I have notified STB of the problem and have not gotten a reply from them!
Would video bios shadow enabled make any difference?

Thanks,
Stan

Carolyn Brill wrote in message <6kemlh$h0...@adesknews2.autodesk.com>...

[Stan Hampton]

Carolyn,
Also when working w/ 3dfaces they display broken or dashed when zoomed in
close.
and the plot preview shows a light gray border around the edged, about 1/3
inside the paper area.

[Carolyn Brill]

Check your driver settings and see if they allow you to set down the
acceleration. This might be a work around until STB can come up with a
better driver.

Carolyn Brill
ACAD Product Support, US
WW Support & Services, Autodesk
Discussion Q&A: http://www.autodesk.com/discussion

Stan Hampton wrote in message <6khm5e$i3...@adesknews2.autodesk.com>...

[Stan Hampton]

This seems to have solved my problem.
What effects will this have on my system?

Carolyn Brill wrote in message <6lgqot$qt...@adesknews2.autodesk.com>...