Windows 95, R13, Hitachi 1515D Digitizer

[Josh Stump]

I have release 13 running on Windows 95. I am attempting to get my Hitachi
HDG-1515D digitizer to work correctly. AutoCAD has a configuration file for
the Hitachi HDG-1515B, but not the HDG-1515D, so I use the HDG-1515B
configuration file. I have the Dip switches set with all switches off.
This puts it in Hitachi standard format at 9,600 bps, 7 bits, Even Parity,
and one Stop bit. It is connected to Com port 1. I went to the Control
Panel and into Devices in System and set Com 1 up with those settings. Upon
booting up the digitizer beeps as usual. It even works for a little while,
but then it gives an error stating that "The operating system detected the
following error(s) on com1. Digitizer disabled. *Transmit queue full."
Could someone please help me get it working properly. (P.S. In the near
future I am installing AutoCAD R14, would it work with it perhaps?) Please
e-mail me at jst...@presys.com

[Carolyn Brill]

Josh-
The digitizer could be sharing an irq address with another device that is on
the system. THis would cause it to need reinitialization.

Carolyn Brill
ACAD Product Support, US
WW Support & Services, Autodesk
Discussion Q&A: http://www.autodesk.com/discussion

Josh Stump wrote in message <6gg2lg$jg...@adesknews2.autodesk.com>...