Trim most of the large leaves off. Cut the trunk off as low to the ground
as you can. Dig a hole at least 18 inches deep and plonk it in. Wet the
hole thoroughly and fill it. Water the fern every day for the next few
weeks, all over the trunk, fronds and around the trunk.
--
Stephen Oakes
This method is for Dicksonia (ie the ones you usually see
sold as bare trunks in the nurseries). Cyathea stems should
not be cut as they usually don't produce new roots from the
cut stem. Cyatheas can, however, be moved but you'll have to
dig out the rootball.
Andrew
Can Dicksonias also be moved by digging out the rootball (just in case
the original poster is unsure of whether they have a Dicksonia or a
Cyathea)?
Tish
Yes. Digging them out is just more back breaking :-)
If it is a dicksonia antarctica, you can safely dig it up, or even saw it in
half and plant the top. If it is a cyathea cooperii, then it will most likely
die.
Just thought I would add to the bit about sawing. It may be easier to use a
chainsaw, but don't, the cutter bar oil can kill it.
This is true. The best saw to use is a bushman's saw.
And it is easy to tell the difference. Dicksonia frond bases are covered
with reddish hairs, Cyatheas have silvery or golden scales.
"Stephen Oakes" <soa...@bigpond.net.au> wrote in message
news:68nc9.5111$Dr5....@news-server.bigpond.net.au...