Windows 8.1 + RME Fireface UFX ASIO + Audiolense

[Marcus Tallhamn]

I've been trying to take measurements with Audiolense. I've set up a pair of 4-way speakers and sending signals to them works fine. So far so good.

However, I can't Audiolense to pick up the input from the microphone preamp. My understanding is that in ASIO mode the mic is supposed to be on channel 9, but I cycled through all 60 i/o channels just in case without any luck. 

The mixer application for the soundcard is receiving input on the mic, as shown in the screenshot below. Any ideas on what might be wrong? I'm using:

- Audiolense 4.9.5120.1026

- RME Fireface UFX DSP SW: 1.56

- Totalmix FX: 0.997

- Windows: 8.1 Pro

Thanks!

[Bernt Ronningsbakk]

Hi Marcus,

 

My guess is that this has to do how the mixer is configured. Unfortunately I am not familiar with RME and the Totalmix FX. Hopefully somebody else can give you advice here.

 

Kind regards,

 

Bernt

--
--
Audiolense User Forum.
http://groups.google.com/group/audiolense?hl=en?hl=en
To post to this group, send email to audio...@googlegroups.com
To unsubscribe, send email to audiolense+...@googlegroups.com
 
---
You received this message because you are subscribed to the Google Groups "Audiolense User Forum" group.
To unsubscribe from this group and stop receiving emails from it, send an email to audiolense+...@googlegroups.com.
For more options, visit https://groups.google.com/groups/opt_out.

[JB]

Hi Marcus,

I have RME Fireface UC. I could post a screenshoot of my totalmix and matrix if you would like.

Or have you sortet it out?

PS.If channel 9 is specified in Audiolense this should correspond to channel 10 on your soundcard.

Best Regards,

Jarle

[Marcus Tallhamn]

I downloaded Audiolense 4.9 and it is able to read the microphone plugged into Fireface UFX microphone input #9 on ASIO channel #8.

Thanks for your help!

Marcus