RED TAG THAT RIGHT NOW
Changes in cutting performance pretty much suggests disaster has occurred.
Be in in a minute to check on it.
Danny
So I came in today and started a cut and about a minute in to the cut I noticed that although the air pressure switch was on, the air gauge was reading zero. The knob on top of the regulator was loose and air was bleeding out of it. I don't know how long that was happening earlier in the day, but the laser doesn't seem to be cutting as well as it should -- settings that used to work fine for MDF don't make it all the way through and the kerf is unusually wide.
flip
--
You received this message because you are subscribed to the Google Groups "ATXHS Discuss" group.
To unsubscribe from this group and stop receiving emails from it, send an email to atxhs-discus...@googlegroups.com.
To post to this group, send email to atxhs-...@googlegroups.com.
Visit this group at https://groups.google.com/group/atxhs-discuss.
For more options, visit https://groups.google.com/d/optout.
I don't see any problem with it. Lens is fine, air pressure builds, there is no leak around the reg, and the focus is dead on.
???
Green tag. Can't find any problem.
Danny
You received this message because you are subscribed to a topic in the Google Groups "ATXHS Discuss" group.
To unsubscribe from this topic, visit https://groups.google.com/d/topic/atxhs-discuss/OpFBix82lY0/unsubscribe.
To unsubscribe from this group and all its topics, send an email to atxhs-discus...@googlegroups.com.
To post to this group, send email to atxhs-...@googlegroups.com.
Visit this group at https://groups.google.com/group/atxhs-discuss.
For more options, visit https://groups.google.com/d/optout.