маленькие победы

20 views
Skip to first unread message

Pavel Kosenkov

unread,
May 15, 2008, 8:41:24 AM5/15/08
to ARM9&FPGA evolution board
U-Boot> boot

NAND read: device 0 offset 0xa0000, size 0x200000
 2097152 bytes read: OK
## Booting kernel from Legacy Image at 21000000 ...
  Image Name:   Linux-2.6.26-rc2
  Image Type:   ARM Linux Kernel Image (uncompressed)
  Data Size:    1175976 Bytes =  1.1 MB
  Load Address: 20008000
  Entry Point:  20008000
  Verifying Checksum ... OK
  Loading Kernel Image ... OK
OK

Starting kernel ...

Uncompressing Linux.........................
....................................................
done, .
Linux version 2.6.26-rc2 (slapin@slapin-notebook) (gcc version 4.1.0
(CodeSourcery ARM 2006q1-6)) #7 Th8
CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=00053177
Machine: Atmel AT91SAM9260-EK
Memory policy: ECC disabled, Data cache writeback
Clocks: CPU 180 MHz, master 90 MHz, main 18.432 MHz
CPU0: D VIVT write-back cache
CPU0: I cache: 8192 bytes, associativity 4, 32 byte lines, 64 sets
CPU0: D cache: 8192 bytes, associativity 4, 32 byte lines, 64 sets
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 8128
Kernel command line: console=ttyS0,115200 root=/dev/mtdblock2 rw
rootfstype=jffs2
AT91: 96 gpio irqs in 3 banks
PID hash table entries: 128 (order: 7, 512 bytes)
Console: colour dummy device 80x30
console [ttyS0] enabled
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 32MB = 32MB total
Memory: 30000KB available (2136K code, 189K data, 108K init)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
net_namespace: 192 bytes
NET: Registered protocol family 16
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
NET: Registered protocol family 1
NetWinder Floating Point Emulator V0.97 (double precision)
JFFS2 version 2.2. (NAND) �(c) 2001-2006 Red Hat, Inc.
msgmni has been set to 58 for ipc namespace c0245fd8
io scheduler noop registered
io scheduler anticipatory registered (default)
atmel_usart.0: ttyS0 at MMIO 0xfefff200 (irq = 1) is a ATMEL_SERIAL
atmel_usart.1: ttyS1 at MMIO 0xfffb0000 (irq = 6) is a ATMEL_SERIAL
atmel_usart.2: ttyS2 at MMIO 0xfffb4000 (irq = 7) is a ATMEL_SERIAL
brd: module loaded
ssc ssc.0: Atmel SSC device at 0xc2870000 (irq 14)
MACB_mii_bus: probed
eth0: no PHY found
Driver 'sd' needs updating - please use bus_type methods
NAND device: Manufacturer ID: 0xec, Chip ID: 0xda (Samsung NAND 256MiB
3,3V 8-bit)
Scanning device for bad blocks
Bad eraseblock 78 at 0x009c0000
Bad eraseblock 216 at 0x01b00000
Bad eraseblock 218 at 0x01b40000
Bad eraseblock 368 at 0x02e00000
Bad eraseblock 697 at 0x05720000
Bad eraseblock 1730 at 0x0d840000
Bad eraseblock 1873 at 0x0ea20000
Creating 3 MTD partitions on "NAND 256MiB 3,3V 8-bit":
0x00000000-0x000a0000 : "bootloader"
0x000a0000-0x002a0000 : "kernel"
0x002a0000-0x10000000 : "rootfs"
usbmon: debugfs is not available
at91_ohci at91_ohci: AT91 OHCI
at91_ohci at91_ohci: new USB bus registered, assigned bus number 1
at91_ohci at91_ohci: irq 20, io mem 0x00500000
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
udc: at91_udc version 3 May 2006
mice: PS/2 mouse device common for all mice
rtc-at91sam9 at91_rtt.0: rtc core: registered at91_rtt as rtc0
rtc-at91sam9 at91_rtt.0: rtc0: SET TIME!
i2c /dev entries driver
i2c-gpio i2c-gpio: using pins 55 (SDA) and 56 (SCL)
TCP cubic registered
NET: Registered protocol family 17
rtc-at91sam9 at91_rtt.0: hctosys: unable to read the hardware clock
VFS: Mounted root (jffs2 filesystem).
Freeing init memory: 108K


--
C уважением (With best regards),
Косенков Павел (Kosenkov Pavel)
aka microtrigger & burokrat
==========================
no time to loose, no time to choose

microt...@gmail.com

unread,
May 16, 2008, 4:07:54 PM5/16/08
to ARM9&FPGA evolution board
обновление

RomBOOT
>AT91B/s @< 0x8400

bad locations: 0x00000000

df code: 0x00000014>AT45DB021B
........
> complete, [0x00039000] bytes


U-Boot 1.3.3-rc3-00056-ge664b73-dirty (May 13 2008 - 23:43:01)

DRAM: 32 MB
NAND: 256 MiB
DataFlash:AT45DB021
Nb pages: 1024
Page Size: 264
Size= 270336 bytes
Logical address: 0xD0000000
Area 0: D0000000 to D00041FF Bootstrap
Area 1: D0004200 to D00083FF Environment
Area 2: D0008400 to D0041FFF U-Boot
In: serial
Out: serial
Err: serial
Net: macb0
macb0: No PHY present
Hit any key to stop autoboot: 0

NAND read: device 0 offset 0xa0000, size 0x200000
2097152 bytes read: OK
## Booting kernel from Legacy Image at 21000000 ...
Image Name: Linux-2.6.26-rc2
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 1176452 Bytes = 1.1 MB
Load Address: 20008000
Entry Point: 20008000
Verifying Checksum ... OK
Loading Kernel Image ... OK
OK

Starting kernel ...

Uncompressing
Linux.............................................................................
done, .
Linux version 2.6.26-rc2 (slapin@slapin-notebook) (gcc version 4.1.0
(CodeSourcery ARM 2006q1-6)) #9 Fr8
CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=00053177
Machine: Atmel AT91SAM9260-EK
Memory policy: ECC disabled, Data cache writeback
Clocks: CPU 180 MHz, master 90 MHz, main 18.432 MHz
CPU0: D VIVT write-back cache
CPU0: I cache: 8192 bytes, associativity 4, 32 byte lines, 64 sets
CPU0: D cache: 8192 bytes, associativity 4, 32 byte lines, 64 sets
Built 1 zonelists in Zone order, mobility grouping on. Total pages:
8128
Kernel command line: console=ttyS0,115200 root=/dev/mtdblock2 rw
rootfstype=jffs2
AT91: 96 gpio irqs in 3 banks
PID hash table entries: 128 (order: 7, 512 bytes)
Console: colour dummy device 80x30
console [ttyS0] enabled
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 32MB = 32MB total
Memory: 29992KB available (2144K code, 188K data, 108K init)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
net_namespace: 192 bytes
NET: Registered protocol family 16
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
NET: Registered protocol family 1
NetWinder Floating Point Emulator V0.97 (double precision)
JFFS2 version 2.2. (NAND) �(c) 2001-2006 Red Hat, Inc.
msgmni has been set to 58 for ipc namespace c02480a0
i2c /dev entries driver
i2c-gpio i2c-gpio: using pins 55 (SDA) and 56 (SCL)
TCP cubic registered
NET: Registered protocol family 17
rtc-at91sam9 at91_rtt.0: setting system clock to 1970-01-01 00:15:56
UTC (956)
Empty flash at 0x00458b50 ends at 0x00459000
VFS: Mounted root (jffs2 filesystem).
Freeing init memory: 108K
INIT: version 2.86 booting
.udev/ already exists on the static /dev!
Starting the hotplug events dispatcher udevd
Synthesizing the initial hotplug events
Waiting for /dev to be fully populated
Remounting root file system...
mount: Mounting proc on /proc failed: Device or resource busy
WARNING: Couldn't open directory /lib/modules/2.6.26-rc2: No such file
or directory
FATAL: Could not open /lib/modules/2.6.26-rc2/modules.dep.temp for
writing: No such file or directory
root: mount: Mounting rootfs on / failed: No such file or directory
Setting up IP spoofing protection: rp_filter.
Configuring network interfaces... udhcpc (v1.2.1) started
udhcpc[2528]: udhcpc (v1.2.1) started
SIOCGIFINDEX failed!: No such device
udhcpc[2528]: SIOCGIFINDEX failed!: No such device
done.
Starting to configure packages...
Nothing to be done
Finished to configure packages.
INIT: Entering runlevel: 5
Starting Dropbear SSH server: dropbear.
Starting syslogd/klogd: done

.-------.
| | .-.
| | |-----.-----.-----.| | .----..-----.-----.
| | | __ | ---'| '--.| .-'| | |
| | | | | |--- || --'| | | ' | | | |
'---'---'--'--'--. |-----''----''--' '-----'-'-'-'
-' |
'---'

The Angstrom Distribution at91sam9263ek ttyS0

Angstrom 2007.12-r14 at91sam9263ek ttyS0

at91sam9263ek login:

Serge Vakulenko

unread,
May 16, 2008, 4:40:04 PM5/16/08
to ARM9&FPGA evolution board
> at91sam9263ek login:

Круто! Поздравляю с первым логином. :)
___
Сергей

Pavel Kosenkov

unread,
May 16, 2008, 5:06:29 PM5/16/08
to arm9fpga-evo...@googlegroups.com
спасибоот общего коллектива трудящихся)


17 мая 2008 г. 0:40 пользователь Serge Vakulenko <serge.v...@gmail.com> написал:
Reply all
Reply to author
Forward
0 new messages