Transferring Calibrated parameters back to SWAT from SWAT-CUP
8 views
Skip to first unread message
Ashwin Ghimire
Jun 1, 2026, 10:29:22 PM (2 days ago) Jun 1
to ArcSWAT
Dear All,
After I succesfully calibrated my model to get a certain NSE (0.7) for flow in SWAT-CUP, I decided to transfer it back to my SWAT model to get my watershed summary in output.std since SWAT-CUP does not give me an updated TxtInOut after calibration and only gives me best fit for parameters.
When I do that, I do not get the same NSE and am very very far off from the NSE I should be getting. All I did was used model.in to get the best fit from SWAT-CUP and update the .mdb database and then wrote the txtinout and ran the swat model again.
The NSE is very poor. Any help would be appreciated because my assumption was that I was done with my modeling.
Thank you.
Sincerely,
Ashwin
After I succesfully calibrated my model to get a certain NSE (0.7) for flow in SWAT-CUP, I decided to transfer it back to my SWAT model to get my watershed summary in output.std since SWAT-CUP does not give me an updated TxtInOut after calibration and only gives me best fit for parameters.
When I do that, I do not get the same NSE and am very very far off from the NSE I should be getting. All I did was used model.in to get the best fit from SWAT-CUP and update the .mdb database and then wrote the txtinout and ran the swat model again.
The NSE is very poor. Any help would be appreciated because my assumption was that I was done with my modeling.
Thank you.
Sincerely,
Ashwin
Reply all
Reply to author
Forward
0 new messages