It might have been me but maybe just offline individually to amplify something said on the forum. While I did find it possible to configure the stratux to roll reverse for AvareX by doing the opposite of the stratux-provided instructions via their config web page, that seemed very clunky -- and it then reversed the stratux internal PFD display. That seems like a lot to ask, especially if you're not a stratux DIY'er like me.
So, hopefully you'll find the AvareX automagic stratux detection/reversal acceptible. Should be much easier for folks, preserves the stratux PFD depiction (see attached picture of both), and aligns with your no-config "just works" goal.
BTW, I'm fortunate to have my UF office <1nm from GNV so my stratux can tune the ADSB tower on the field for UAT/weather data, and get traffic which due to proximity causes alerts (audible, orange disk), so test cases are pretty good.
Blue Skies!