the basics for a first cycle

51 views
Skip to first unread message

SETH W

unread,
Apr 26, 2020, 1:12:35 PM4/26/20
to Anabolics Anonymous

O.K. here are the basics for a first cycle


A. if there is another way besides hormones ie. natural testosterone boosting with TEST UP or with S.A.R.M.s like, LGD-4033, RAD, ETC that is the way to go so the natural hormone cycle is not replaced and the orchestra we call the endocrine system is not abruptly altered like when replacing hormones completely with steroids and prohormones 


B. If you are going to run a hormone then note that in the average male shutdown of natural production of testosterone starts at 10 weeks (that is average some earlier and some later no way to tell where you will fall except the higher body fat the more likely to get gyno and shutdown production entirely)


1.Start with 100-250mg per week of testosterone either cyp or enanth or sust (can split doses like Sun and Wed) after 4-5weeks if you are not still gaining muscle you can up dose to 500mg a week or split doses of 250. (remember the damage is in the dose) That is also based on an average person weighing in at 175 or more less weight less receptors less hormone needed


2. TESTUP, Arimi-T, Clomid or nolva should be on hand in case of gyno symptoms run 1/2 dose during cycle to stop the effects (for me Clomid actually reversed the progression during cycle and it has never been a problem again and that was at only 1/2 dose clomid 25mg daily for 3 weeks)


3. Start PCT 1 week after last pin for Cyp or Enanth, 2-3 weeks after for Sust (Clomid 50mg daily for 1 week then 100mg ED for 2-3 weeks... Nolva (40mg daily for 1 week, 20mg daily week 2, 10mg daily for 2 more weeks) and if you were running tren or deca you may need a dopamine antagonist for any issues with gyno especially if lactating 


4. If you have testicular shrinkage, have ran more than 2 cycles, have ran for more than 10 weeks, have ran more than 4 compounds, suspect you have low T or just want your body to produce the maximum test possible naturally and want to retain all muscle gains then add TESTUP to your PCT program starting the day of your last pin. This will give your body what it uses to rebuild the testicles to full size and test output, will stimulate the highest possible amount of test your nuts can make without the worry of side effects (your body will never hurt itself by overproduction) and TESTUP will mildly block estrogen it also contains Milk thistle to help the liver cleanse and after 6 months of use you should have your testicles permanently producing your max amount of test. Provided you d o not shut them down again


5. If you have ran more than 2 cycles, have been on TRT for more than 6 months, have ran for more than 10 weeks, have ran more than 4 compounds at once during your cycle, have just ate like crap for years and feel like crap use Kidney Liver Cleanse to clean up after a cycle and to get all extra bloating and or water weight off. Add I3C-DIM to it to cleanse receptors that may have been stopped up during your cycle or if you feel you have become immune to the compound. This will make your compounds fresh to your receptors again. 

Furthermore to ensure liver health IP-6 with milk thistle is the best Liver cleansing and healing compound to date with studies showing it goes so far as to reverse liver cancer and even cirrosis 


6. You may also run Ostarine or LGD (add RAD and or S-4 to any cycle or you can stack with Ost, LGD or about anything) after your cycle to continue gains and strength increases or use as a bridge between cycles to hit the receptors from a different angle or if you are doing TRT or a blast and cruise method these can be used with your PCT. Just be sure you get it from a legit source so you can avoid unknown sides from questionable products. 


7. If you have joint issues add MSM+C for lubrication and if you have full blown arthritis add MK-677, MSM+C and Ultra Joint Health to possibly rebuild and regrow cartilage.


You can find SARMs, TESTUP, MSM+C, Kidney Liver Cleanse, I3C-DIM here Newroids

set...@att.net

Reply all
Reply to author
Forward
0 new messages