PoBe <
par.olov....@gmail.com> writes:
>I just got VT103 which I'm trying to connect to a VAXstation 90A. I have remove all backplane cards except for the terminal controller and attached STP (Standard Terminal Port) connector. (Cabel J1 and J2 are not connected to anything).
>I plug-in the console cable into the EIA communication port (25 pin). I SETUP the VT103 to match the communication on the VAX console port i.e. 9600B, 8-N-1. But cannot get it to work.
>However when using the same cable and connector and plug-in it to a PC com running a terminal emulator 9600B, 8-N-1. it work nicely.
>
Do you have the baud rate configured correctly? Number of stop bits?
Is it configured to require RTS/CTS or is it just using Tx/RX/GND?
>