Kapton thin film heaters

[Sam Goldwasser]

I have a need for small quantities of the kind of thin film heaters
that are used in stabilized HeNe lasers.

What's a good supplier in small quantities? Minco will happily talk
to you but has a $1000 minimum for most models and no samples.

I need a sample now and perhaps 10-50 total over several years.

The approximate specs would be 3 inch x 3 inch and about 10 ohms.

Thanks!

--
sam | Sci.Electronics.Repair FAQ: http://www.repairfaq.org/
Repair | Main Table of Contents: http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ: http://www.repairfaq.org/sam/lasersam.htm
| Mirror Sites: http://www.repairfaq.org/REPAIR/F_mirror.html

Important: Anything sent to the email address in the message header above is
ignored unless my full name AND either lasers or electronics is included in the
subject line. Or, you can contact me via the Feedback Form in the FAQs.

[James Sweet]

Sam Goldwasser wrote:
> I have a need for small quantities of the kind of thin film heaters
> that are used in stabilized HeNe lasers.
>
> What's a good supplier in small quantities? Minco will happily talk
> to you but has a $1000 minimum for most models and no samples.
>
> I need a sample now and perhaps 10-50 total over several years.
>
> The approximate specs would be 3 inch x 3 inch and about 10 ohms.
>
> Thanks!
>
>

I know I've seen these at one of the surplus places, Electronic Goldmine
perhaps?

[Samuel M. Goldwasser]

James Sweet <james...@trashmail.net> writes:

Thanks, but unless I have better luck than the Lottery, this really
has to be rather specific size and ohms.