andrewwayc...@gmail.com
unread,May 18, 2020, 2:29:12 PM5/18/20You do not have permission to delete messages in this group
Sign in to report message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to
Hi there,
I have a working 315M DPSS laser, with the controller power supply a weird autostart dongle without the ready light...
I am trying holography again (thanks Fred unterseher) in my livingroom with this new laser, but I think it may be having trouble stabilizing.
It starts up just fine, but when I run it though the interferometer it performs this “breathing” routine, where the fringe pattern moves a little in a regular manner every 3-4 seconds contracting in. I have eliminated the possibility of table, pump, or fan movement- as my cheapo chinesium diode laser settles just fine in no time. (I converted it to water cooled, but The weird fringe behavior persists with the pump off for 15 mins).
I have tried the recommendations in the laser faq for this model, DC voltage is good/stable, checked all ribbon cable conn’s (visually, is hate to brick it by poking around with a multimeter). I have also tried adjusting the pot down for a lower current/power setting to no avail- it resets and takes its 6mins to find a new stable setting, but the fringes never settle.
I do not have a oscilloscope or power meter handy as of yet, but it seems to be stuck in a loop. Any suggestions would be appreciated.
-Roo