Google Groups no longer supports new Usenet posts or subscriptions. Historical content remains viewable.
Dismiss

Using Tub Spout with Diverter when there's no shower head

513 views
Skip to first unread message

Todd

unread,
Jun 14, 2009, 11:30:22 PM6/14/09
to
Folks,

I've got a new 8 inch tub spout with a diverter on it. I'd like to
use it on my new tub (that lacks a shower.) Any chance that I can use
a tub spout with a diverter in it even if there is no where to divert
to? Are there any issues with it?


- Thanks,

Todd

Phisherman

unread,
Jun 15, 2009, 6:42:15 AM6/15/09
to

It should work fine. If you have a mixing valve with a shower line, it
should be capped off.

DerbyDad03

unread,
Jun 15, 2009, 8:33:16 AM6/15/09
to

Just install a stub in the shower outlet and cap it off.

But why would you want a diverter if you don't need one?

The "handle to nowhere" would bother me.

zxcvbob

unread,
Jun 15, 2009, 10:02:41 AM6/15/09
to


When someone drips the diverter valve it will close, and trap the water
pressure behind in. Depending on how well it seals, how are you going
to open it again? If you shut off the mixer valve, you'll trap pressure
between the two valves, keeping the diverter closed.

Since water is not compressible, it doesn't have to leak much to keep
this from being a problem, just thought I would mention it.

Bob

Todd

unread,
Jun 19, 2009, 11:09:16 PM6/19/09
to

I don't _want_ a diverter. I happen to have an 8 inch tub spout that
has a diverter. Can't find the same tub spout without the diverter. So
I was wondering if there was a big problem with using it.

SteveBell

unread,
Jun 20, 2009, 4:01:45 PM6/20/09
to
Todd | 2009-06-19 | 10:09:16 PM wrote:

>I don't want a diverter. I happen to have an 8 inch tub spout that


>has a diverter. Can't find the same tub spout without the diverter. So
>I was wondering if there was a big problem with using it.

Worst case scenario: The water is on full force, and someone lifts the
diverter.

If the diverter seals well (usually only on a new spout), then the
water will just stop flowing. You will have to turn off the faucets
before you can lower the diverter. The diverter might be difficult to
lower because of static water pressure, but that will go away in a
minute. The diverter might possibly drop by itself.

If the diverter _doesn't_ seal well, usually from water deposits, then
you'll get a decreased flow from the spout. You'll probably still be
able to raise and lower the diverter with the water on.

I'm assuming the shower pipe is well capped.

--
Steve Bell
New Life Home Improvement
Arlington, TX USA

BetaB4

unread,
Jun 22, 2009, 2:22:14 PM6/22/09
to

Maybe you can "defeat" the diverter mechanism. By that, I mean that maybe
you can look inside the spout and see how the diverter mechanism works, and
how it seals off the flow of water. There may be a way to remove or take
out the plastic part that actually makes the seal.


0 new messages