Thanks.
Dorothy
H
"JJVandJMB" <jjva...@aol.com> wrote in message
news:20020302155626...@mb-dd.aol.com...
Only if it is a gas dryer, than YES!!!!
In fact if it is a gas dryer, flexible nylon venting is illegal in most places
and should be totally replaced ASAP. Rigid ducting is recommended in most cases
and flexible metal ducting should only be used for short runs as the corrugated
surface hampers air flow which causes increased lint build up in side if it and
can also cause poor drying results.
Dan O.
-
Appliance411.com
http://ng.Appliance411.com/?ref411=gas+dryer
=Ð~~~~~~
Joe
Think so? Put a CO meter in the vent and see...
>However, a super sealed house could be in
> trouble because oxygen gets used up and is replaced by carbon dioxide. CO2
is
> not lethal, but it doesn't support life, either,
Co2 tanks all have warnings on them, and CO2 actually DOES suport
life...plant life.
>so the bad effects are like
> drowning. CO is poisonous, displacing oxygen in our hemoglobin.
> Regardless, fix the defective vent the right way, right away.
There ya go..we agree on that.
>
> Joe
The flame in a gas dryer gets plenty of excess air because the purpose is to
only heat the air moderately. Under such circumstances (gross excess air)
it is close to impossible to generate CO. Fireplace inserts that are
designed to be ventless generate essentially no CO for the same reason:
plenty of excess air.
VENTED heating appliances (with the exception of dryers) are adjusted to
have very little excess air and some CO will be generated.
And buy Co2 detectors. The alternative is much more expensive.
"Dorot29701" <dorot...@aol.com> wrote in message
news:20020302161245...@mb-cu.aol.com...
Truthfully, I don't know. The dryer is in a friend's house. She mentioned that
she was getting a burning smell from the dryer. I looked behind it and saw that
the vent line had a gaping hole, which is when I threw the question out to the
group regarding the possibility of carbon monoxide leaking. For what it's
worth, their stove is electric.
Anyhow, does this sound like a fire hazard?
John
2. You can do it if you are inclined. If it has a real heavy cord plugged
into a large receptacle, it is electric. If it is electric you cannot get
any carbon monoxide. If it is electric, pull the machine forward. Remove
the vent hose, and pull as far forward as possible. Reach your hand into
the hole to see if it is full of lint. Reach your hand into the hose as far
as possible to see if it is full of lint.
3. Plug the machine in and start it without the hose. Let it run and get
hot. If it still has a burning smell, further disassembly may be required.
I assume that the lint screen is being cleaned. There is a possibility that
the thermostat needs to be replaced if the upper limit stat is not shutting
off the current. If this is starting to sound beyond your expertise, go to
item 1.
--
@@@@@@@@
Keep the whole world singing . . . . . . .
Dan & Dee Griffin