Google Groups no longer supports new Usenet posts or subscriptions. Historical content remains viewable.
Dismiss

8 foot ceilings in garage... Gas IR heating tube OK?

210 views
Skip to first unread message

Me

unread,
Nov 18, 2009, 12:16:29 AM11/18/09
to
I'm going to be installing heat into my garage in the next month or so and I
was wondering what would work.

Garage is 24'x32'. I have a natural gas line and electricity. Ceilings are
eight feet.

I do plan on some painting/staining, so I'd like to avoid the air currents
caused by forced air gas heat.

I'm considering a 15 foot natural gas IR heater, vented the remaining 9 feet
to the outside of the garage so to scavange any extra heat I can from the
exhaust. Air intake on one side of the garage. Exhaust on the other side.

Does this sound OK? Can an IR heater be installed with the eight foot
ceilings, or are they meant for higher ceilings? Should I bother trying to
scavange some of the exhaust heat?

Thanks!

Joe

unread,
Nov 18, 2009, 2:31:49 PM11/18/09
to

Better have a real long talk with a customer service person at your
proposed heater manufacturer. The 8' ceiling is much lower than on
installations I have seen. You might also talk with building
inspection people in your city to get some good advice and to prevent
stumbling over some odd ball regulation that could affect your
project. Keep in mind that painting and staining with gas fires
present has in the past resulted in some spectacular conflagrations.
Check with local auto body shops to see how they handle similar kinds
of work with regards to heaters.

Joe

hal...@aol.com

unread,
Nov 18, 2009, 3:00:48 PM11/18/09
to

The cheapest way is a forced air gas furnace, drect vent, and a walled
off area for paintaing staing etc,.''

The heat tubes are radiant, they will heat only the stuff in the
building not the building itself

ransley

unread,
Nov 19, 2009, 8:25:29 AM11/19/09
to
On Nov 17, 11:16 pm, "Me" <Dont.s...@me.here> wrote:

Is that a vented unit or are you making your own theoretical -
experimental venting. I know little about this except you need a
vented unit and have to follow proper set up or Co will get you. I
would not expeiment a DIY vent. I would have a thermometer probe above
the unit to be sure you keep what is above it below the recomended
temperature. A Co detector would be needed to be sure you are safe. I
just saw a spec sheet and it gave mounting height to ceiling and the
temp max of above ceiling. You do know Radiant does not heat air, it
heats objects that heat the air, I would not want one of those facing
a car or my work to be painted.

DD_BobK

unread,
Nov 20, 2009, 2:16:54 AM11/20/09
to

An 8' ceiling height seems a bit too low for an IR heater where I
assume you'll be standing and working.

Outdoor restaurant seating with IR heaters has me concerned that the
top of my head might blister. Depending on the heater location
relative to your work area...you might be WAY too close.

cheers
Bob

0 new messages