Google Groups no longer supports new Usenet posts or subscriptions. Historical content remains viewable.
Dismiss

GE Profile Dishwasher error code HrF and beeping

1,258 views
Skip to first unread message

Rick Boucher

unread,
Dec 9, 2021, 11:31:07 AM12/9/21
to
Just installed new GE Profile Dishwasher.
Went to test and run it empty.
This is what happens.
1. select quick wash
2. close door
3. select start
4. water begins to flow into tub
5. Can here relay clicking under machine
5. water then pumps out of tub
6. Machine then starts beeping and flashed HrF on LED panel..

I ran all the service tests. Door check ok, Water fills, water pumps, spray arms work, water drains, heater element works.
Just wont cycle.
Any help?

DONNIE

unread,
Sep 11, 2022, 2:15:09 PM9/11/22
to
I’m having the same problem. Did you find out what it was?

--
For full context, visit https://www.homeownershub.com/maintenance/ge-profile-dishwasher-error-code-hrf-and-beeping-3173753-.htm

Rickrd

unread,
Sep 11, 2022, 4:01:41 PM9/11/22
to
Ended up having to call service. They came and found that it was a bad control board

Jon

unread,
Apr 7, 2023, 6:32:13 PM4/7/23
to
Having same issue. Installed by Best Buy 3 days ago and ran fine for a load or two, the get HrF error code and it will not run and beeps for several minutes.

Bob F

unread,
Apr 7, 2023, 6:38:07 PM4/7/23
to
On 4/7/2023 3:32 PM, Jon wrote:
> Having same issue. Installed by Best Buy 3 days ago and ran fine for a
> load or two, the get HrF error code and it will not run and beeps for
> several minutes.
>

Sounds like time for a warranty call.

Retirednoguilt

unread,
Apr 8, 2023, 9:40:05 AM4/8/23
to
On 4/7/2023 6:32 PM, Jon wrote:
> Having same issue. Installed by Best Buy 3 days ago and ran fine for a
> load or two, the get HrF error code and it will not run and beeps for
> several minutes.
>

Two suggestions I found on the web:

1. Reset the control panel by unplugging the dishwasher (or using the
circuit breaker for the circuit powering the dishwasher) for 10 minutes
and then restore power.

2. Press the “start” button for five seconds. It will flash. Now, press
both the “start” and the “select cycle” button down at the same time for
five seconds. The control panel should be cleared. It should light up
with everything operating normally.

Worth a try before wasting a day waiting for a technician.

doubleds

unread,
Dec 4, 2023, 12:03:57 AM12/4/23
to
THANK YOU FOR THE INFORMATION THAT WORKED FOR OUR PEOBLEM!!!
Thanks again
0 new messages