Tony
Tony, I have a Rockola starlet. What symtoms do you have when they
need replaced? Thanks, Jerry
Normally the record plays slow, sometimes you get a loud hum. If you
lift and remove the turntable you will find the motor hanging from 3
grommets. They should be soft and pliable. If they get hard you can
get the vibration from the motor finding it's way to the needle and
cartridge and you have a hum. Most of the time they deteriorate and the
motor starts to hang sideways, that's when it plays slow. If you change
them, don't loose the spacer inside of them. (I think I just saw John
mention that not long ago) And when you replace the turntable, push the
idler wheel (the rubber wheel) in and under the turntable or it won't
play at all.
Tony
Good Gawd! I found someone else selling them for $4.66 a piece!
Hi
$6.00 for another 20 years or so, I recon that is cheap.
They cost 5.2 Euro on the Stamann website www.jukebox-world.de for the
three grommets.
Regards
Alan Hood
ami-man
UK
--
Alan Hood
I suppose you are right. But why pay $2/piece when I just found them
for $0.56 a piece. $4.95 per PKG of 9
Some more of us have Rock-Olas and like good parts prices. Why not
share your info? Ray
I left it out just as a tease. Or maybe I should buy them and sell them
for $1.50? Nah, here you go
click on "Rubber & Antenna Items/Phono" then to "Motor Mounting Grommets".
I bought 3 packs of 9, I repair jukes for a living. So one could
imagine the reason I didn't want to pay $2 a piece. If I only needed
them for one juke it wouldn't be too bad, but the difference between
$14.85 and $56. is quite considerable.
Tony
Many thanks to Tony and others for the grommet source tip. I need
these for my 1455. My metal spacers are missing, and would appreciate
information and /or a source on the proper size so I can either make
3, or buy them.
I also need the 2 smaller grommets for my tone arm which I am
rebuilding and repainting. The grommets crumbled when I disassembled,
but were very dry and loose before I took this apart - lots of side
play on the pivot pin.
Does anyone know a source for the 2 small tonearm grommets? Or
perhaps the size I should look for at a radio supply store?
Thanks Jack