Google Groups no longer supports new Usenet posts or subscriptions. Historical content remains viewable.
Dismiss
22RE Oil Pan removal
168 views
Skip to first unread message
Pat Smith
Jul 19, 2000, 3:00:00 AM7/19/00
to
I am trying to remove my oil pan on a 22 RE engine 4X4 and don't have
enough clearance to pull it out. Please tell me what I need to do to get
this off. Thanks
'88 4runner
enough clearance to pull it out. Please tell me what I need to do to get
this off. Thanks
'88 4runner
mark and ellen smith
Jul 20, 2000, 3:00:00 AM7/20/00
to
Pat,
Jack the front end (not the frame) enough to stretch the suspension a few
inches, not enough to lift the tires off the ground, then wiggle the pan
out. Cursing a little seems to help.
Jack the front end (not the frame) enough to stretch the suspension a few
inches, not enough to lift the tires off the ground, then wiggle the pan
out. Cursing a little seems to help.
Mark Smith
mws...@ptialaska.net
Pat Smith <vif...@home.com> wrote in message
news:39763BED...@home.com...
FourX4freak
Jul 20, 2000, 3:00:00 AM7/20/00
to
The steering linkage has to be disconnected and also you need to remove the
crossmember. Hope this helps. Good luck.
crossmember. Hope this helps. Good luck.
Sherry Hildebrand
Jul 20, 2000, 3:00:00 AM7/20/00
to
reach in there and remove the pickup tube.this should give enough clearance
N2Frodn
Jul 25, 2000, 3:00:00 AM7/25/00
to
1.Drop all the pan bolts
2.Take the 4 bolts out that hold the engine mounts to the frame.
3. Jack up the engine slightly. ( I used the lip between the engine and
trans for the jack point).
4. Pull the pan down as far as it will go
5. Reach in between the pan and the block and remove the 4 bolts that hold
the oil pick up tube, let tube drop into the pan
6.wiggle and tilt pan out the front of the truck (easier if the radiator and
fan are out)
7. Sit back and have a beer (or several) and rejoice in your mechanical
skill
8. Ponder how hard it is to get the pickup tube bolted back on (it is doable
but a real pain in the ass)
Hope this helps,
Rich
86 Toyota 4x4
66 Buick Skylark
www.toyotas.freeservers.com
2.Take the 4 bolts out that hold the engine mounts to the frame.
3. Jack up the engine slightly. ( I used the lip between the engine and
trans for the jack point).
4. Pull the pan down as far as it will go
5. Reach in between the pan and the block and remove the 4 bolts that hold
the oil pick up tube, let tube drop into the pan
6.wiggle and tilt pan out the front of the truck (easier if the radiator and
fan are out)
7. Sit back and have a beer (or several) and rejoice in your mechanical
skill
8. Ponder how hard it is to get the pickup tube bolted back on (it is doable
but a real pain in the ass)
Hope this helps,
Rich
86 Toyota 4x4
66 Buick Skylark
www.toyotas.freeservers.com
0 new messages