Serial5 Bricked

[Dale Hoepner]

Hello all,

I have been working on a basic program for an AIRcable Serial 5 and I seem to have loaded a program that no longer allows me to access either the +++ command line interface or to attach to the Bluetooth interface with my PC.  I need some way to reset this back to factory defaults.  I have tried using obexftp from my windows command line but it failed to connect.  Is there any other way to do this?

[Juergen Kienhoefer]

No, you can't brick it.

Dale,

You can remove all BASIC code and get back to factory reset, which is just FTP and no BASIC code.

Open up the Serial5 and you see two silver pads  on top next to the 4-switch. Shorten these, power up,

wait about 15 seconds, power down and remove the short.

Then you have a steady blue light, which means that the BASIC code is not running but FTP is.

Upload the code again.

You get all our BASIC code examples here:

https://aircable.co/shop/product/aircable-basic-code-examples-46?category=2

On Wed, Feb 17, 2016 at 5:11 AM, Dale Hoepner <dlhoe...@gmail.com> wrote:

Hello all,

I have been working on a basic program for an AIRcable Serial 5 and I seem to have loaded a program that no longer allows me to access either the +++ command line interface or to attach to the Bluetooth interface with my PC.  I need some way to reset this back to factory defaults.  I have tried using obexftp from my windows command line but it failed to connect.  Is there any other way to do this?

--
You received this message because you are subscribed to the Google Groups "AIRcable(tm)" group.
To unsubscribe from this group and stop receiving emails from it, send an email to aircable+u...@googlegroups.com.
To post to this group, send email to airc...@googlegroups.com.
Visit this group at https://groups.google.com/group/aircable.
For more options, visit https://groups.google.com/d/optout.

[Dale Hoepner]