How to use thermostat control strategy in the series vehicle rather than the default power follower?

Joshua Pennington

unread,

Jul 28, 2020, 3:36:42 PM7/28/20

to ADVISOR and adv-vehicle-sim Software Discussion Forum

I have opened the block diagram BD_series then opened the control strategy block and can see the two yellow blocks labelled thermostat and power follower which can be seen in the attached photo.

I can't find in any literature or help online about how to switch from the default (power follower) to thermostat.

BD_series_control_block.png

Michael P O'Keefe

unread,

Jul 28, 2020, 8:31:01 PM7/28/20

to ADVISOR and adv-vehicle-sim Software Discussion Forum

There should be a place in the user interface to change the control strategy. You shouldn't have to directly interact with the block diagrams (unless doing something advanced). Check the "PTC" powertrain control and "CS" control strategy variables.

http://adv-vehicle-sim.sourceforge.net/advisor_ch3.html#3.2.5

Mohan R

unread,

Oct 29, 2020, 1:07:03 PM10/29/20

to ADVISOR and adv-vehicle-sim Software Discussion Forum

for example, we have to add one block which is in the Simulink library to the advisor block diagram.then what is the procedure we have to follow?

Byte of CNN

unread,

Nov 11, 2020, 6:03:28 PM11/11/20

to ADVISOR and adv-vehicle-sim Software Discussion Forum

default of fuel cell is the power follower or the thermosat?

Reply all

Reply to author

Forward