LabVIEW Interface for Arduino - Stepper Motor - 4 wire

[kilkenn...@gmail.com]

I am working on a project to make a 3D printer using stepper motors. I am currently trying to control a single 4-wire stepper motor using LabVIEW Interface for Arduino. On the "Stepper Configure.vi" I have changed the "Control Method" to 4-wire. I now want to specificy pins 3, 11, 12 and 13 but every time I run the "Stepper Motor.vi" it reverts back to the default pins 2 and 3 and the final two boxes become greyed out. Does anybody know how to change the "Stepper Configure.vi" permantly to pins 3, 11, 12 and 13?

[Sandy Noble]

This is a list for the accelstepper library - I think you have already asked in a better place (https://decibel.ni.com/content/thread/18222?tstart=0).

sn

On 17 August 2013 13:07, <kilkenn...@gmail.com> wrote:

I am working on a project to make a 3D printer using stepper motors. I am currently trying to control a single 4-wire stepper motor using LabVIEW Interface for Arduino. On the "Stepper Configure.vi" I have changed the "Control Method" to 4-wire. I now want to specificy pins 3, 11, 12 and 13 but every time I run the "Stepper Motor.vi" it reverts back to the default pins 2 and 3 and the final two boxes become greyed out. Does anybody know how to change the "Stepper Configure.vi" permantly to pins 3, 11, 12 and 13?

--
You received this message because you are subscribed to the Google Groups "accelstepper" group.
To unsubscribe from this group and stop receiving emails from it, send an email to accelstepper...@googlegroups.com.
For more options, visit https://groups.google.com/groups/opt_out.

--
Sandy Noble