Glazing system boundary condition for Glazing unit in Model

94 views
Skip to first unread message

Adella Nov

unread,
Jul 24, 2025, 12:21:09 PMJul 24
to THERM
Hi,

I have been using Therm 8.0 and have tried to run a model. However, an error message stating 'the file has glazing system boundary condition names (which are generated when the glazing system is imported from WINDOW) that do not match the name of the Glazing System. To use the WINDOW- generated Boundary Conditions for the Glazing System, regenerate the boundary conditions. To keep the non-WINDOW generated Boundary Conditions for the Glazing System, go to Options>Preferences>THERM File Options and change the setting that enforces the rule.'

I have tried to regenerate the boundary conditions and I still see the error message. I have also imported glazing from a model that runs well however, it still does not work.

Is there any way of rectifying this?

Adella Nov

unread,
Jul 24, 2025, 12:22:06 PMJul 24
to THERM
This is the screenshot
SCS.png

Robin Mitchell

unread,
Jul 24, 2025, 12:42:02 PMJul 24
to Adella Nov, THERM
Can you provide the model?

Robin Mitchell
Building Technology and Urban Systems Division
Energy Technologies Area
Lawrence Berkeley National Laboratory


--
You can view the THERM forum online at:
https://groups.google.com/g/LBNL-THERM
---
You received this message because you are subscribed to the Google Groups "THERM" group.
To unsubscribe from this group and stop receiving emails from it, send an email to LBNL-THERM+...@googlegroups.com.
To view this discussion visit https://groups.google.com/d/msgid/LBNL-THERM/6e03b6d9-60cf-4185-bdb5-92f6e159fa99n%40googlegroups.com.

Adella Nov

unread,
Jul 25, 2025, 4:35:55 AMJul 25
to THERM
2_Jamb_Brick_AB_Condensation Analysis.THM

Robin Mitchell

unread,
Jul 25, 2025, 1:35:05 PMJul 25
to Adella Nov, THERM
I am looking at your file now

Robin



--

Robin Mitchell

unread,
Jul 25, 2025, 1:53:07 PMJul 25
to Adella Nov, THERM
I was able to get this file to simulate, but I did it in THERM 7.8.80, rather than 8.0, which is really still a beta version. 

I have attached my file, but I probably don't have the Boundary Conditions right, so make sure to check those. 

There were lots of areas where there were many unnecessary points, so I cleaned those up, so that it would mesh. 

image.png
image.png
image.png
image.png
2_Jamb_Brick_AB_Condensation Analysis-RM.thm

Hamid BADI

unread,
Jul 29, 2025, 6:28:51 AMJul 29
to THERM
I do found the same result
result-Jamb.png

Adella Nov

unread,
Sep 1, 2025, 8:44:16 AM (4 days ago) Sep 1
to THERM
Hi,

Why do I keep getting the same message?

Reply all
Reply to author
Forward
0 new messages