Mesh Generation error

86 views
Skip to first unread message

Zulong Liu

unread,
Jul 15, 2025, 9:42:24 AMJul 15
to THERM
Hi,Everyone.

         I am a green hand by using THERM(VERSION 7.8.80.0),it continuously get an message of mesh error as I had do a lot of effort to modify the model.
       This error comes when I imported a warm edge spacer.This model is running well with normal spacers and the warm edge spacer is running well in other models(mullion,transom).But when I combined them together the problem comes.
       It will be highly appeariciated if  anyone help to check and point out the problem?

      Bruce,

Horizontal -Spanderal-warm edge.THM

Zugur Rakhmanov

unread,
Jul 15, 2025, 10:50:06 AMJul 15
to Zulong Liu, THERM
Hi Zulong,
As I remember there was a rule of modeling in the Therm that warned the distance between a polygon vertices should be more than 0.1mm.
image.png
Try to redesign the steel part of the edge spacer and run again.


Kind regards,

Zugur

--
You can view the THERM forum online at:
https://groups.google.com/g/LBNL-THERM
---
You received this message because you are subscribed to the Google Groups "THERM" group.
To unsubscribe from this group and stop receiving emails from it, send an email to LBNL-THERM+...@googlegroups.com.
To view this discussion visit https://groups.google.com/d/msgid/LBNL-THERM/f40859f5-5814-4aeb-b718-80618127f9aan%40googlegroups.com.

Zugur Rakhmanov

unread,
Jul 16, 2025, 5:06:29 AMJul 16
to Zulong Liu, THERM
Hi Zulong,
Now I have tried to run your file and it's working after a little revision(divided some polygons).
Try to open it and run on your computer.
image.png

Additionally, check all the outside boundary conditions set by you, actually for bottom IGU (see the screenshot below)
64af21df-9a96-40ca-bf1f-75067866c326.png


Kind regards,

Zugur

On Wed, Jul 16, 2025 at 10:47 AM Zulong Liu <liuzul...@gmail.com> wrote:
Zugur,

Thank you for your quick reply, I have got more knowledge about THERM, I still have a little confuse that the same spacer in other model is ruuning well,why in this model have problem? Redesign the spacer seems have a little big work for me now as  I have 6 details need to be replaced,is there any other easy way to slove 11.PNG
Regrads!
Horizontal -Spanderal-warm edge_1.THM

Zulong Liu

unread,
Jul 18, 2025, 10:45:33 AMJul 18
to THERM
Hi,Zugur
Thank you for your hard work,It is running well in my computer,and thank you for you reminder for the boundary,I made a mistake There.I learned a lot from the case and got more information and rules of THERM.

Reply all
Reply to author
Forward
0 new messages