Groups keyboard shortcuts have been updated
Dismiss
See shortcuts

Cl glazing boundary conditions error

78 views
Skip to first unread message

Brianna Galvan

unread,
Oct 23, 2020, 4:05:53 PM10/23/20
to THERM
Hello, (THERM 7.7)

I am am currently modeling a parapet corner vertical detail but am getting the following error 
"THERM detected an error in the Cl glazing boundary conditions. Please verify that there are no extra points on the glazing cavity surface." 

I previously ran the model but have since made some updates to the geometry so am not sure what is causing this error to occur. 
I was hoping someone can let me know if they have ran into this issue before and if they know how to resolve it.



My models can be found here:

Thank you! 

Robin Mitchell

unread,
Oct 27, 2020, 2:02:55 PM10/27/20
to Brianna Galvan, THERM
of the three files in the drive folder, which is the one with the problem? 

Robin

--
You can view the THERM forum online at: http://windows.lbl.gov/software/THERM/forum
---
You received this message because you are subscribed to the Google Groups "THERM" group.
To unsubscribe from this group and stop receiving emails from it, send an email to LBNL-THERM+...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/LBNL-THERM/05b36d43-07b8-4b47-aece-7088151ef083o%40googlegroups.com.


--
Robin Mitchell
Building Technology and Urban Systems Division
Energy Technologies Area
Lawrence Berkeley National Laboratory

Brianna Galvan

unread,
Oct 28, 2020, 11:04:10 AM10/28/20
to THERM
Hi Robin,

Thank you for the response. @marlesmcdonald was already able to give me feedback on the issue which helped me resolve the problem, thanks. 

"This error indicates an extra point in the IG cavity when I make the mistake it is usually because I moved a spacer or other element within the cavity."

The issue was with the IG cavity in the lower cavity on the right side near the spacer. 

To resolve it I redrew the spacer and then reimported the window. 


Thank you again.


On Tuesday, October 27, 2020 at 1:02:55 PM UTC-5, Robin Mitchell wrote:
of the three files in the drive folder, which is the one with the problem? 

Robin

On Fri, Oct 23, 2020 at 1:05 PM 'Brianna Galvan' via THERM <LBNL-...@googlegroups.com> wrote:
Hello, (THERM 7.7)

I am am currently modeling a parapet corner vertical detail but am getting the following error 
"THERM detected an error in the Cl glazing boundary conditions. Please verify that there are no extra points on the glazing cavity surface." 

I previously ran the model but have since made some updates to the geometry so am not sure what is causing this error to occur. 
I was hoping someone can let me know if they have ran into this issue before and if they know how to resolve it.



My models can be found here:

Thank you! 

--
You can view the THERM forum online at: http://windows.lbl.gov/software/THERM/forum
---
You received this message because you are subscribed to the Google Groups "THERM" group.
To unsubscribe from this group and stop receiving emails from it, send an email to LBNL-...@googlegroups.com.
Reply all
Reply to author
Forward
0 new messages