2007 gsa ESA code 41768

82 views
Skip to first unread message

Dano

unread,
Jun 29, 2020, 7:15:07 PM6/29/20
to GS-911 Field Diagnostic Tool for BMW motorcycles
My 2007 GSA with 73000kms on it will not go into dampening mode on rear shock.  Have tried engine on and off not moving obviously and have pulled apart the 2 wiring harnesses and sprayed with contact cleaner.  Tried the calibration with the 911 and only heard a small noise from shock then got a fail to calibrate.  Tried it with bike on centre stand but that did not help.  Any ideas out there.  I am long past warranty. 

David Howard

unread,
Jun 29, 2020, 8:32:13 PM6/29/20
to gs-...@googlegroups.com

--
You received this message because you are subscribed to the Google Groups "GS-911 Field Diagnostic Tool for BMW motorcycles" group.
To unsubscribe from this group and stop receiving emails from it, send an email to gs-911+un...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/gs-911/0ab93ca3-c179-4bb5-b479-1df5d864ad01o%40googlegroups.com.

Budi Sujanto

unread,
Jun 29, 2020, 9:51:35 PM6/29/20
to gs-...@googlegroups.com
Just for your reference
 
From: Dano
Sent: Tuesday, 30 June 2020 06:15
Subject: [GS-911] 2007 gsa ESA code 41768
 
My 2007 GSA with 73000kms on it will not go into dampening mode on rear shock.  Have tried engine on and off not moving obviously and have pulled apart the 2 wiring harnesses and sprayed with contact cleaner.  Tried the calibration with the 911 and only heard a small noise from shock then got a fail to calibrate.  Tried it with bike on centre stand but that did not help.  Any ideas out there.  I am long past warranty. 

Dano

unread,
Jul 6, 2020, 8:02:22 AM7/6/20
to GS-911 Field Diagnostic Tool for BMW motorcycles
Ok have gone over a few things in past days. First is i made a mistake and bike is 2009 not 2007. I pulled the shock and motor turns. Was able to make a jumper and can raise and lower it. Found out that it is 2.5 mm per setting i.e. one up two up etc. Max is 10mm. So that i know works. I het no feed back when doing calibration as to sensor setting still are 0 and 0. Where the front is 33 and 1138 i think. Is there anyway to replace the sensor in these shocks? 3260 for new plus tax here in Canada.
Reply all
Reply to author
Forward
0 new messages