Building the Gen 3: Issues with Step 32 Coin sensor mount does not fit.

[Jason Wainwright (Xcaliber777)]

I have previously built the Gen 2 version of the crowbox and I am now building the Gen 3. I have stepped through all of the previous steps with much success prior to the Step 32 video with little to no issues. However, when trying to install the coin sensor mount to the bottom of the crowbox, I found that it did not align properly. Either the laser cutting or the reinforcement plate to the base or the size of the coin sensor mount was too wide. I had to sand down one side in order to get the 6mm screws to align properly. It wasn't a big deal, but thought I would share.