Intermitten Operation
23 views
Skip to first unread message
Gerry Siegel
Sep 20, 2009, 9:34:23 AM9/20/09
to C0-L...@googlegroups.com
I hadn't used my lathe for a couple of months and when I went to turn it on
it wouldn't start. I made sure the chip shield was down and tried again, and it
still wouldn't go. After fooling with it started and then when I turned it off
it wouldn't start again.
Anyone had this trounle? Anyone have a solution? The lathe is fairly new
and has not had a great deal of use.
Gerry Siegel
thething
Sep 22, 2009, 1:25:14 PM9/22/09
to Sieg C0 Baby Lathe
Yep, I've got that exact thing. I am quite certain its the pot/switch
that causes this. I say this because once I get it to start, if I
don't click it all the way off when stopping, the thing will always
restart when I turn the pot up again. This can't be a safe way to
operate but its the only way it starts consistantly. I plan to take
it apart and see what part the pot/switch is so I can replace it with
something decent.
Jim
that causes this. I say this because once I get it to start, if I
don't click it all the way off when stopping, the thing will always
restart when I turn the pot up again. This can't be a safe way to
operate but its the only way it starts consistantly. I plan to take
it apart and see what part the pot/switch is so I can replace it with
something decent.
Jim
Reply all
Reply to author
Forward
0 new messages